INSTALLATION
OPTIONAL WALL | OPTIONAL REMOTE |
THERMOSTAT | CONTROL |
FINAL CHECK
A wall thermostat may be installed if desired. Connect the wires as per the wiring diagrams. Note that the wires are connected to the "TH" on the gas valve. Use table on page 14 to determine the maximum wire length:
Note: Preferable if the thermostat is in- stalled on an interior wall.
Regency offers an optional programmable ther- mostat but any
CAUTION
Do not connect the millivolt
wall thermostat wires
to the 120V wires.
Use the Regency Remote Control Kit approved for this unit. Use of other systems may void your warranty.
The remote control kit comes with a hand held transmitter, a receiver and a wall mounting plate.
1)Choose a convenient location on the wall to install the receiver and the receptacle box (protection from extreme heat is very im- portant). Run wires from the fireplace to that location, use Thermostat Wire Table.
2)Connect the wires as per the wiring dia- gram above.
CAUTION
Do not connect the millivolt
remote control wires to
the 120V wires.
3)Install 3 AAA alkaline batteries in transmit- ter and 4 AA alkaline batteries in the receiver. Install the receiver and its cover in the wall. Switch the remote receiver to "remote" mode. The remote control is now ready for operation.
Thermostat Wire Table
Recommended Maximum Lead Length
Thermostat
|
| Wire Size | Max. Length | ||||||
|
|
|
| 14 GA. | 50 Ft. | ||||
|
|
|
| 16 GA. | 32 Ft. | ||||
|
|
|
| 18 GA. | 20 Ft. | ||||
|
|
|
| 20 GA. | 12 Ft. | ||||
|
|
|
| 22 GA. | 9 Ft. | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Before leaving this unit with the customer, the installer must ensure that the appliance is firing correctly. This includes:
1)Clocking the appliance to ensure the cor- rect firing rate (rate noted on label) at 15 minutes.
2)If required, adjusting the primary air to ensure that the flame does not carbon. First allow the unit to burn for 15 min. to stabilize.
CAUTION
Any alteration to the product that causes sooting or carboning that results in dam- age to the exterior facia is not the respon- sibility of the manufacturer.
3)Ensuring that the appliance is venting cor- rectly. See page 8.
12 | Regency |