Regency U38-NG, U38-LP Pins on Rear Log Support, PinCutout, Lava rock, Notch Cutout

INSTALLATION

3) Place Rear Log A)02-65 on the two pins on	7) Place the Left Top Log D)02-46 on the pin
the rear log support.	on Log B)02-56 and on top of the cutout on
	Log A)02-65.

11)Position notch in Front Right Log G)02-48 on Log F)02-47 and push the bottom right edge against the bracket on the burner tray.

-65

Pins on Rear Log Support

4)Place the Middle Left Log B)02-56 on the two pins as shown.

B)02-56

A)02-65

D)02-46

-

C)02-44

PinCutout

8)Place Front Right Log E)02-45 on the two pins as shown.

E)02-45

48

-65

-

Notch

G)02-48

45

5)Sprinkle some lava rock just in front of B) 02-56 on the burner holes.

B)02-56

lava rock

6)Place Front Left Log C)02-44 onto the 2 front pins as shown.

9)Place the lava rock in the area between the left and right logs, leaving a space in the middle for log (F) 02-47.

10)Place the notch in Center Log F)02-47 over Log E)02-45 and across the cutout on Log A)02-65.

Bracket

The bottom right edge of Log G)02-48 must

sit snugly against the bracket

12)Test fire to ensure proper light off (make sure flame flows smoothly from one end of burner to the other. If there is any flame hesitation, check that area for any block- age of the burner port.

-

-46	-
	-

B)02-56 E)02-45

C)02-44

-44 -

-65

E)02-45

Notch Cutout

Regency U38 ULTIMATE Freestanding Gas Heater 11