Regency F38-LPG2, F38-NG2 Aeration Adjustment, LOG SET Installation, F38-2 with 38 mj

INSTALLATION

AERATION

ADJUSTMENT

The burner aeration is factory set but may need adjusting due to either the local gas supply or altitude.

F38-2 with 38 mj

F38-NG2	NG:	Full open
F38-LPG2	LPG:	6.4 mm open

Caution: Carbon will be produced if the air shutter is closed too much.

Note: Any damage due to carboning re- sulting from improperly setting the aeration controls is NOT covered under warranty.

LOG SET

INSTALLATION

Read the instructions below carefully and refer to the diagrams. If logs are broken do not use the unit until they are replaced. Broken logs can interfere with the pilot operation.

The gas log kit contains the following:

a)02-65 Rear Log

b)02-56 Middle Left Log

c)02-44 Front Left Log

d)02-46 Left Top Log

e)02-45 Front Right Log

f)02-47 Center Log

g)02-48 Middle Right Log

h)	Embers	902-151
i)	Lava	902-154

Note: Install Optional Brick Panels prior to installing logs.

The "02" refer numbers (i.e. 02-65) are

molded into the rear of each log.

1)Carefully remove the logs from the box and unwrap them. The logs are fragile, handle with care - do not force into position.

2)Sprinkle the embers on the left and right sides of the firebox base.

3)Place Rear Log A)02-65 on the two pins on the rear log support.

A)02-65

Pins on Rear Log Support

4)Place the Middle Left Log B)02-56 on the two pins as shown.

B)02-56

5)Place Front Left Log C)02-44 onto the 2 front pins as shown.

C)02-44

Embers.Embers

Regency F38-2 Freestanding Gas Heater 9