Regency P48-1 installation manual Removing Valve, Shut off the gas supply

REMOVING VALVE

7)Remove the right and left side deflectors by removing the 2 screws on each deflector.

1)Shut off the gas supply.

2)Remove the louvers (and bay door if it has been installed).

3)Open the flush door and remove the door.

4)Remove the logs and side brick panels, if installed.

5)Remove the grate by lifting up and out.

Grate

6)Remove the burner by removing the screw on the left side and then slide the burner to the left and lift out.

Remove the screw on the left

side of the burner.

Right Side

Deflector

Left Side

Deflector

8)Remove the base brick panels.

9)Disconnect the inlet gas line.

10)Remove the 10 Phillips head screws secur- ing the valve tray assembly in place and then lift the entire assembly out.

Lift entire valve tray

assembly out.

11)Disconnect the 2 TP wires and the 2 TH wires from the valve.

12)Undo the pilot tube from the valve with a 7/ 16" wrench.

13)Undo the quick drop out thermocouple nut on the valve with a 9mm (metric) wrench.

14)Remove the Piezo igniter wire and push button assembly.

15)Undo the "gas out" flare nut with a 13/16" wrench.

16)Undo the "gas out" flare fitting with an 11/ 16" wrench.

17)Remove the 4 Phillips head screws from the sides of the valve bracket and remove valve.

Slide the burner to the left and lift out.

Hint: If you are using black pipe, ensure that there is a union by the valve, otherwise removal will be almost impossible.

Valve Tray

Assembly