Pella 818K0100 Frame Screw Method, In-swing Open door panels drill, Hinge Jambs See

G R A D E & H U R R I C A N E S H I E L D D O O R S • P E R F O R M A N C E U P G R A D E

5INSTALL THE PERFORMANCE UPGRADE OR HURRICANESHIELD FASTENERS

Frame Screw Method: In-Swing

Note: If installing with installation clips,		5A	6"	16" MAX O.C.	6"	6" 16" MAX O.C. 6"
proceed to Step E.
A. Jambs:
Out-swing:On the room side of the jamb;		Clearance				Clearance
drill and counter-sink 13/64" deep diameter		Hole				Hole
		Location				Location
clearance holes through the door frame
only and not into the rough opening in the
locations shown. (See Out-Swing diagram in
lower right).
In-swing: Open door panels; drill and		Clearance				Clearance
		Hole				Hole
counter-sink 13/64" deep diameter clearance		Location				Location
holes through the door frame only and not
into the rough opening in the locations shown.
(On hinge jambs; clearance hole locations are
centered between hinges).			6"	16" MAX O.C.	6"	6" 16" MAX O.C. 6"
	INTERIOR	Out-Swing				INTERIOR
Hinge Jambs: See		Drill 13/64" clearance holes
(5A) In-Swing diagram		5A	through the frame
(upper right). Fixed and
Lock jambs diagram for
placement of threshold
screws and installation	EXTERIOR			EXTERIOR
clips (see out-swing
diagram in lower right).	INTERIOR	In-Swing				INTERIOR

Vent	Vent
Placement
	Placement

Fixed		Drill 13/64"	Fixed
Placement	5A	clearance holes	Placement
		through the frame
	EXTERIOR		EXTERIOR

B.Drill 13/64" deep clearance holes through the door frame head only and not into the rough opening in the locations shown.

C.Drill 1/8" x 1" deep pilot holes through the clearance holes and into the rough opening framing in the head, jambs, and threshold of the unit frame.

Note: Be certain to shim between jambs and rough opening at all screw locations.

P E R F O R M A N C E U P

DIAGRAM FOR

PLACEMENT OF

FRAME SCREWS &

INSTALLATION CLIPS

Out-Swing Sill	In-Swing Sill
Out-Swing Sill

Screw

Location

	OUT-SWING					IN-SWING AND OUT-SWING
	DOUBLE OPERABLE					SINGLE FIXED OR OPERABLE
			5B				5B
		6"
6"	16" MAX	6"	16" MAX	6"		6"	16" MAX	6"
	O.C.		O.C.				O.C.
6"					6"	6"		6"
5A					5A	5A		5A
16"					16"	16"		16"
MAX.					MAX.	MAX.		MAX.
O.C.					O.C.	O.C.		O.C.
6"					6"	6"		6"
6"	16" MAX	6"	16" MAX	6"		6"	16" MAX	6"
	O.C.	6"	O.C.				O.C.
		5E					5E