Doors Without adjustable hinges, Hinge

of sealant into the three sill strike holes and install the three # 8 x 3" ﬂat head stainless steel screws (provided) into the holes.

K.Shim between the frame and the rough opening at the head strike location and

D O O R S • A L L D O O R S • A L L D O O R S • A L L D O O R S

at every frame anchor hole location. Remove and replace head strike screws with three #8 x 3" corrosion resistant screws (provided) through the head strike, door frame, shims and into the rough opening.

Note: For doors with no head strike check head for pre-drilled installation holes. If installation holes are present drill 1/8" pilot in each installation hole and install a #8 x 3" screw (provided).

L.On each hinge, starting at the top, insert a corrosion resistant screw (#12 x 2-1/2" for out-swing or #8 x 3" for in-swing; provided)

into the open screw hole. Make sure the screw passes through the shims and into the structural framing.

Interior

• A L L D O O R S • A L L D O O R S • A L L

M. Check door operation. Open and close
the door to check for proper operation.
Make sure the door will latch correctly.
Note: If there are any problems with
the operation, check to conﬁrm the
door frame is installed plumb, level
and square. If the reveal between the
door panel(s) and frame is not even,
adjustments may be made:
Doors WITHOUT adjustable hinges:
Plastic shims located behind the hinges
may be removed to adjust the reveal
between the door panel and door frame.
Additional hinge shims may be added	Adjustable
if required.	Hinge

Non-Adjustable

Hinge

D O O R S

Note: Doors with adjustable hinges will have a (+)(-) on the door panel hinge leaf to indicate possible adjustments and doors without adjustable hinges do not have adjustment indicators.

Adjustable hinges are not designed to make up for failure to install the door frame correctly. Before adjusting hinges, conﬁrm the door is installed plumb, level and square.