L L D O O R S, O O R S a L L D O O R | Pella 818K0100 specification

S • A L L D O O R S

D. Plumb and square door. Place shims at each hinge	3DÓ
and lock strike location between the door and the sides
of the opening. Keep shims back 1/2" from interior
face of the door frame. Insert shims in other locations
as needed starting up 6" from the bottom of the door
to square it in the opening. Make sure that the reveal
around the door(s) is equal. On double doors, make
sure that panels are even across the bottom.

Note: On center latch double doors the lock strike will not be shimmed since it is located in the center of the unit. DO NOT over shim.

&YUFSJPS

L D O O R S • A L L D O O R

E.Check the interior reveal. Make sure the measurement from the

	interior face of the door to the	3E
	interior face of the wall is equal	3E
	interior face of the wall is equal
	at several points around the door.
	And the door is plumb in the
	opening. It may be necessary to
	shim between the wall and the
	brickmould to ensure the door is
	plum during the remainder of the
	installation steps.

mm	1	INCHES		2
	20	30	40	2		3
			40	50	60	3
					60	70

Interior

L L D O O R S • A L

F.Fasten the door to opening by driving 16d galvanized ﬁnishing nails through the brickmould or ﬂat casing 6" from each corner and not more than 10" on center.

16d galvanized

ﬁnishing nails

Exterior

D O O R S • A L L D O O R S • A L L D O O R S • A

G. Carefully open the door(s) and remove all

shipping spacers.

Note: Be sure to remove the spacers from the bottom edge of the door panel. Use the construction handle to operate both the active and passive door panels.

Double door with Center Latch: Use the construction handle to operate both the active and passive door panels.

H.For Out-Swing Standard Installation Applications Only: Install sill screws. Remove the threshold screws and insert a #8 x 3" stainless steel screw (provided) into each hole. For masonry ﬂoors use a 3/16 masonry screw in place of the provided screw, pilot drill per screw manufacturer’s recommendations.

Note: On In-Swing Door Standard Installation, sill screws are not needed.

SILL SCREWS FOR ARCHITECT SERIES PERFORMANCE UPGRADE AND DOORS WITH HURRICANESHIELD IMPACT-RESISTANT GLASS ARE INSTALLED IN STEP 5.

I.For Low Proﬁle Sills through each installation screw hole drill a 1/8" pilot; and install a #8 x 3" corrosion resistant screw (provided) into the pilot hole into the ﬂoor. For doors including a standard lock install tubs per instruction included with the sill strike package.

Note: For concrete ﬂoors use masonry screws that are a minimum size of 3/16" diameter x 2" and pilot per manufacturer’s recommendations for the screw.

J.Remove sill strike screws from the sill strike located on the door sill. Place a dab