Infiniti PS-10, PS-12 manual System Connections, Set LFE/Normal switch to LFE

SYSTEM CONNECTIONS

If you have a Dolby* Digital or DTS® receiver/processor with a low-frequency-effects (LFE) or subwoofer output:

Set LFE/Normal switch to “LFE.”

SUBWOOFER OR

LFE OUTPUT

LEVEL

Green: On	Min	Max
Red: Stand-By
	LFE	NORMAL
	PHASE 0º	180º
	80Hz
CROSSOVER
FREQUENCY
	50Hz	150Hz
	L	R
LINE LEVEL IN
	For LFE use L or R

If your receiver/processor does not have subwoofer outputs for the left and right channels or an LFE output, connect speaker wire from your receiver/amplifier to your speakers and subwoofer using two sets of speaker wire:

RECEIVER/AMPLIFIER

Front Speaker Output

LEVEL

Green: On
Red: Stand-By	Min	Max

LFE NORMAL

PHASE 0º 180º

80Hz

CROSSOVER

FREQUENCY

50Hz150Hz

L R

LINE LEVEL IN

For LFE use L or R

L

HIGH

LEVEL

IN

R

+–

If your receiver/processor does not contain a Dolby Digital or DTS processor but has subwoofer outputs:

RECEIVER/PROCESSOR

L R

Set line-level/LFE switch to “Normal.”

NOTE: If your receiver/processor has only one sub out, you may use either the L or R input.

LEVEL

Green: On	Min	Max
Red: Stand-By
	LFE	NORMAL
	PHASE 0º	180º
	80Hz
CROSSOVER
FREQUENCY
	50Hz	150Hz
	L	R
LINE LEVEL IN
	For LFE use L or R
		L
		HIGH
		LEVEL
		IN

R

+ –

RED = +

BLACK = –￿

1.LOOSEN TERMINALS

2.INSERT BARE END; ￿ TIGHTEN TERMINALS

NO STRIPE = –￿ STRIPE = +

This figure shows how to connect bare wires to the terminals.

PS-10/PS-12 5