GE Monogram ZDW24 BB, ZDW24 WW, ZDB24 WW Models Available Design Information, Installation Options

Page 3

Models

Available

 

Design Information

 

 

 

 

 

 

Beverage Center & Wine Chiller

 

 

 

 

ZDB24 WW

The Monogram beverage center or the wine

 

White Beverage Center

chiller adds an eloquent statement of style,

 

ZDB24 BB

convenience and flexibility.

 

Black Beverage Center

The Monogram beverage center and wine

 

ZDW24 WW

 

chiller can be used freestanding or as a

 

White Wine Chiller

 

built-in.

 

ZDW24 BB

 

 

 

 

Black Wine Chiller

 

 

 

 

 

 

 

Dimensions & Clearances

Front ventilation allows the beverage center or wine chillder to be installed as a built-in and still operate efficiently.

The bottom front grille area must remain unobstructed for proper air circulation and operation.

Cutout dimensions shown allow for a full door swing and access to the pull-out racks.

Locate

Outlet

24" Min.

34-1/2"-35" 5"

24" Min.

34-1/2"

24-1/8" 23-7/8"

Installation Options

Increase storage capacity by installing two Monogram beverage centers side by side or two Monogram wine chillers side by side. Or, install a Monogram beverage center next to a Monogram wine chiller for a complete refreshment center.

A side by side installation requires a 48" wide opening. No trim kits required.

The glass door fronts should align evenly with adjacent cabinet door fronts.

Frameless Cabinets:

If installing between frameless cabinets, a 1/2" wide filler strip or side panel may be required. The filler strip will act as a spacer between the door case and adjacent cabinet and will prevent interference with cabinet door swing. The width of the opening must include filler panels.

Provide two separate properly grounded electrical outlets for a side by side installation. Each electrical outlet should have a voltage rating that matches the rating plate.

3

Image 3
Contents GE Monogram Installation Instructions Beverage Center Contents Frameless Cabinets Installation OptionsDimensions & Clearances Models Available Design InformationUse of Extension Cords Installation PreparationGrounding Use of Adapter plugReverse Door Swing To remove the doorPosition new nameplate Installation Install HandleRemove the Packaging Slide the Unit into the Cutout Install Leveling LegsTo position new nameplate Template