Installation Preparation
Beverage Center & Wine Chiller
Grounding the
Beverage Center or Wine Chiller
IMPORTANT - (Please read carefully)
FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED.
The power cord of this appliance is equipped with a
Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.
Where a standard
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE THIRD (GROUND) PRONG FROM THE POWER CORD.
Use of Adapter plug
Because of potential hazards under certain conditions, we strongly recommend against use of an adapter plug. However, if you still elect to use an adapter, where local codes permit, a TEMPORARY CONNECTION, may be made to a properly grounded
Align Large Prongs/Slots
Ensure Proper Grounding and Firm
Connection Exists Before Use
The larger slot in the adapter must be aligned with the larger slot in the wall outlet to provide proper polarity in the connection of the power cord.
Use of an adapter plug will increase the cutout depth required.
CAUTION
Attaching the adapter ground terminal to a wall outlet cover screw does not ground the appliance unless the cover screw is metal, and not insulated, and the wall outlet is grounded through the house wiring. You should have the circuit checked by a qualified electrician to make sure the outlet is properly grounded.
When disconnecting the power cord from the adapter, always hold the adapter in place with one hand and pulling the power cord with the other hand. If this is not done, the adapter ground terminal is very likely to break with repeated use.
Should the adapter ground terminal break, DO NOT USE the appliance until a proper ground has again been established.
Use of Extension Cords
Because of potential safety hazards under certain conditions, we strongly recommend against the use of an extension cord. However, if you still elect to use an extension cord, it is absolutely necessary that it be a UL listed
PRUDENCE
Brancher la borne de terre d’un adaptateur sur la vis du couvercle de la prise murale ne met pas l’appareil à la terre, sauf si la vis du couvercle est métallique, n’est pas isolée et si la prise murale est mise à la terre par l’intermédiaire des fils de la maison. Il faut faire vérifier le circuit par un électricien qualifié pour s’assurer que la prise est correctement mise à la terre.
4