iRobot 380t, 320 owner manual Using the Pro-Clean Reservoir Pad, Fill the reservoir

Using the Pro-Clean Reservoir Pad

(Sold separately for Braava 320)

The Pro-Clean Reservoir Pad dispenses liquid as Braava mops to keep the cleaning cloth wet longer.

Fill the reservoir

1. Open the fill cap by pulling and swiveling it to the side.

2. Fill reservoir with water and replace fill cap, pressing it in securely so it does not leak.

3.Fill the reservoir over a sink as a small

amount of fluid can leak out when the fill cap is closed.

4. Dampen the blue Pro-Clean microfiber cloth and press onto the velcro strips. Do not use a dry cloth.

TIP: Fluid dispenses at different rates depending on floor type and solution used. The first time you mop, start with the cloth only slightly damp and then increase the starting cloth wetness if needed.

NOTICE: To avoid the Pro-Clean Reservoir Pad leaving excess fluid on your floor, do not leave Braava unattended when mopping and remove from floor once Braava stops cleaning.

When mopping is finished:

•Empty any remaining fluid from the reservoir.

•Leave the fill cap open to allow reservoir to dry completely. Do not store the pad on Braava if wet.

•See page 22 for care instructions.

global.irobot.com 19