Assembly and Operation, Attaching the Handle

ASSEMBLY AND OPERATION

ATTACHING THE HANDLE

The vacuum cleaner and the handle are packed separately.

1.After first removing the handle screw [Fig. 1], position the handle behind the vacuum cleaner and level with the top of the unit. Hold the power cord down and away from the vacuum while the handle is being attached [Fig. 2]. Make sure that the switch on the handle is positioned toward the front of the vacuum cleaner.

2.On the bottom of the handle are two “T-shaped” rails that slide forward onto two guides located on the top of the vacuum cleaner. Line up the handle so that the “T” rails will slide into the guides and push the handle forward [Fig. 3].

3.Insert the handle screw and tighten securely.

4.Attach the power cord at the clip located on the upper cord hook [Fig. 4].

5.Turn the upper cord storage hook to the upright position and wind the power cord around the cord storage hooks when storing the vacuum cleaner.

ON/OFF SWITCH

1.To start the vacuum cleaner, flip the ON/OFF switch (located on the grip on Models 200, 300, and 300C or on the side of dust compartment on Model 100) to the ON position as indicated by “” on the switch [Figs. 5 and 6].

2.To stop the vacuum cleaner, flip the ON/OFF switch to the OFF position as indicated by “t” on the switch.

3.Turn the vacuum cleaner off before unplugging from electrical outlet.

Fig. 1

Fig. 3

Fig. 5

Fig. 2

Fig. 4

Fig. 6