Selecting a sound source
|
| DTR5.1 |
| DVD Player | DIGITAL INPUT |
|
| COAXIAL 2 |
|
| COAXIAL 1 |
|
| OPTICAL 2 |
|
| OPTICAL 1 |
1 |
|
|
DVD |
|
|
2 |
|
|
Digital/ |
|
|
Analog |
|
|
3 |
|
|
Preset/Mode ADJ |
| |
Down | Up |
|
4 |
|
|
Enter |
|
|
5 |
|
|
Preset/Mode ADJ |
| |
Down | Up |
|
6 |
|
|
Enter |
|
|
18 |
|
|
Assigning the digital input/Selecting the input signal format
Assigning the digital input
If another device is connected to the digital input jack of the
Note:
The default setting is “ANALOG.” In this case, you can- not play any digital signals from the digital input jacks (Dolby digital, DTS, etc.).
OPT1 — The
OPT2 — The
COAX1 — The
COAX2 — The
ANALOG — The
Selecting the input signal format
Normally, select AUTO for this parameter. You can also select DIGITAL or ANALOG depending on the source. Follow the steps
AUTO (digital signal/analog signal playback mode) Digital signals have priority for playback. If no digital sig- nals are input, the
The
The
ANALOG (analog signal playback mode)
The
Assume that you have connected a DVD player to the COAXIAL 1 connector.
1.Use the INPUT button to select “DVD.”
2.Press the Digital/Analog button to set digital input. “DGTL/ANLG SETUP” appears, followed by the cur- rent setting (OPT1, OPT2, COAX1, COAX2, or ANA- LOG).
3.Press “Preset/Mode ADJ Ã/¨” to select COAX1.
4.Press the Enter button.
The unit displays “INPUT FORMAT” in a few seconds, followed by the current setting (AUTO, DIGITAL, or ANALOG).
5.Press “Preset/Mode ADJ Ã/¨” to select AUTO, DIGI- TAL or ANALOG.
6.Press the Enter button.
Tip:
You may play analog audio while digital input is selected if you select “ANALOG” in Step 5.
Note:
•You cannot select “INPUT FORMAT” as described in Step 4 if you select “ANALOG” in Step 3.
•You can assign digital input to DVD, VIDEO 1, VIDEO 2, VIDEO 3, TAPE, and CD.