Sanitaire 880 warranty HOW to USE, HOW to Maintain

HOW TO USE

The upright vacuum cleaner is designed to be used on multiple types of carpeting.Do not attempt to use the upright vacuum cleaner on bare floors, as damage to the floor covering may result. Above the floor cleaning tools are available (optional).

HOW TO MAINTAIN

The instructions in this booklet serve as a guide to routine maintenance. To avoid unnecessary service calls, check the bag, belt and brush roll often.

Cleaner Care

Handle Adjustment

1. Store

2. Use

3.Clean

Underneath

Handle Lock

With the tip of the foot, press down to release the handle lock located at the left rear side of the cleaner. Move the handle and adjust it to the desired position for (1) storing upright, (2) operating the cleaner at a comfortable height for the user, and

(3)cleaning underneath low furniture.

CAUTION: Turn off the switch and unplug the electrical cord before cleaning unit.

To keep the vacuum cleaner looking new, it can be wiped with a damp cloth and a mild soap solution, then thoroughly dried. Never use any type of chemical as chemicals can damage the cleaner. When not in use, the cleaner should be stored in a clean, dry place.

EZ Kleen® Dust Cup and Bag

The cloth bag and the dust cup play a very important role in the efficiency of the vacuum cleaner. The cloth bag allows air to move through the cleaner while it traps dirt inside the cloth bag and the dust cup.When dirt particles cling to the cloth bag they can restrict airflow, If air cannot pass through the cloth

Power Switch	ON/OFF
The power switch is
mounted on the handle.
Push ON (-) or OFF (O).

Cleaner Height Setting

WARNING: Avoid injury. Keep loose clothing, hair, fingers, and all other parts of body away from any moving part (such as the revolving brush). Turn off the switch and unplug the cleaner before changing the cleaner height setting.

Adjust the vacuum cleaner height setting to match the carpet pile height.

The front of the cleaner has a knob which raises or lowers the cleaner base to match the type of carpet.With the cleaner cord unplugged, set the adjustment to the lowest setting.

While the cleaner is off and disconnected from the outlet, place the handle in the operating position, tilt the cleaner back to remove the weight from the wheels, and adjust the setting. Then plug the cleaner into the electrical outlet, turn on the switch, lower the handle, and pass the cleaner over the carpet. If the cleaner is still difficult to push, follow the procedure and test the cleaner at the next higher setting. Continue testing the setting until the cleaner is comfortable to move. Moving the knob to the next higher setting raises the brush roll slightly, making the cleaner easier to push. However, the brush roll must make contact with the carpet for effective cleaning.

bag, no cleaning can take place regardless of how powerful the unit. Some fine particles can restrict airflow very quickly and will decrease performance even before the dust cup appears to be full. For that reason, when vacuuming powder, flour dust, or similar fine substances, it may be necessary to turn off the cleaner and empty the dust cup more often.

CAUTION: Turn off the switch and unplug the electrical cord before emptying the dust cup. Never operate the vacuum cleaner without the dust cup latched in place.

1.Unhook

2.Shake Bag

3. Release

Latch

4.Lift Lid

Lock

Push Lift

Down Up

1.Unhook the clip from the top of the cloth bag.

2.Shake the cloth bag to release dust clinging inside.

3.Release each latch, one on either side of the handle (push down on the lock, lift up on the bottom and pull the top forward.)

4.Lift the lid; swing it up and outward.

CAUTION: Keep the latch free of dust or obstructions that would prevent it from locking

securely.5