Sanitaire 880 warranty Brush Roll, How To Replace Worn Brush Strips, Quick Kleen Fan Chamber, C D

7. Replace Cup	5. Remove
	Cup
and Swing
Lid Shut

6. Empty

Cup

5.Reach in, grasp the dust cup and pull it out of the support.

6.Empty contents in a suitable container. (If desired, the cup can be washed in warm water using a mild soap solution. Be sure the cup is completely dry before replacing.)

7.Place the cup into the support, swing the lid shut, and fasten each latch.

8.Hook clip to top of bag (refer to item 1).

Brush Roll

As the brush roll rotates, it sweeps and combs the carpet nap. Remove hair and threads from the brush roll so it continues brushing the carpet nap.When the bristles of the brush roll no longer touch a straight edge held across the bottom plate, the brush roll is ineffective because the bristles no longer touch the carpet nap. To maintain the most effective cleaning, use a new wood brush roll. Replace the brush strips on the chromed steel brush roll.

How To Replace Worn Brush Strips

(chromed steel brush roll)

CAUTION: Turn off the switch and unplug the electrical cord before replacing brush strips.

New brush strips are supplied in sets of two, one long and one short. To replace, remove bottom plate and belt (see How To Change Belt). Then, grasp center of brush roll and lift to remove.

Quick Kleen® Fan Chamber

(880 Series Only)

CAUTION: Turn off the switch and unplug the electrical cord before cleaning.

The clear, removable fan chamber cover provides easy inspection, cleaning, and maintenance of the fan chamber. Removing the cover provides easy access to the motor fan. Grease buildup, dirt, or other obstructions, visible through the fan cover, should be removed. To clean the fan area, take off the chrome bottom plate by releasing the two cam locks (see Brush Roll

Belt, Figure 1 and 2). Remove the belt from the motor pulley, then loosen and remove the screws on either side of the fan cover, as indicated by the arrows. Push the cam locks outward against the wheels to lift the cover from the cleaner base. Dirt and obstructions can easily be cleared; however, caked grease may need to be scraped from the cover and the cleaner. If the fan does not turn freely, it also should be removed for cleaning. To remove the fan, place a wrench over the motor pulley. Hold the fan blades with one hand and turn the wrench counterclockwise. Remove the motor pulley and lift the fan off the motor shaft. Clean the area and replace the fan over the motor shaft. Tighten the motor pulley snugly clockwise with the wrench. If necessary, replace the fan cover or the gasket with replacement parts.

Be sure the gasket is in place. Reposition the fan cover by first placing the exhaust end into place between the large rear wheels. Seat the fan cover firmly. Next replace the belt and bottom plate as the pressure from the bottom plate helps seal the fan cover. Start the two screws by hand to be sure they are straight, then tighten.

Order fan chamber cover replacement kit (fan cover, gasket, two screws) Part No. 52334.

F

E

A B C D

1.Remove rubber end cap cover from one end (A).

2.Unscrew locknut (B).

3.Remove end cap (sleeve bearing brush roll assembly includes a shaft washer, not pictured) (C).

4.Remove bearing retainer (D).

5.Push shaft through opposite end (E).

6.Pull out worn brush strip with pliers (F).

D

TO RE-ASSEMBLE

7.Slide in new brush strip of same length (rounded end first) Fit track on either side of brush strip into brush roll slot (F).

Replace second brush strip from opposite end of brush roll (E).

8.Replace shaft

9.Align indentation on bearing retainer with brush strip on both ends of brush roll (D).

(replace shaft washer on sleeve bearing assembly)

6