Windsor 10052310, SCEX326, SCEOX326, 10052340 Machine Troubleshooting, Problem Cause Solution

MACHINE TROUBLESHOOTING

PROBLEM	CAUSE	SOLUTION
Poor or no water pick-up	Squeegee out of	Adjust squeegee
	adjustment	Remove debris
	Debris caught on squeegee
	Worn squeegee blades	Rotate or replace squeegee
		blades
	Vacuum hose clogged	Clear obstruction from hose
		Reconnect vacuum hose
	Vacuum hose disconnected
	from squeegee or recovery
	tank	Replace vacuum hose
	Vacuum hose damaged
	Recovery tank not sealed	Place recovery tank dome on
		tank. Replace damaged
		gaskets.
	Foam filling recovery tank	Empty recovery tank
		Use less or different detergent
		Use defoamer
Vacuum motor does not run, or	Recovery tank full	Drain recovery tank
runs slowly		Clean float system
	Recovery tank float system
	dirty	Reset circuit breaker
	Circuit breaker tripped
	Loose connection	Check motor wires and
		connections
	Faulty vacuum switch	Replace switch
	Worn vacuum motor	Replace brushes, check
	brushes	commutator
Poor scrubbing performance	Debris caught in scrub	Remove debris
	brushes	Replace brushes or pads
	Worn brushes or pads
	Improper detergent, brush	Contact equipment or
	or pad used	application specialist
	Low scrub brush down	Increase brush pressure
	pressure	Charge batteries
	Low battery charge
Brush motors do not run, or runs	Circuit breaker(s) tripped	Reset circuit breaker(s)
slowly		Check motor wires and
	Loose connection
		connection
	Faulty brush motor	Replace contactor
	contactor	Replace brushes, check
	Worn brush motor brushes
		commutator

CUTTER 36V (SCEX) 86037040 12/12/06 4-13