Windsor MPRO EU 10080400, MPRO AU 10080420, MPRO 10080390 manual Brush Motor Removal, Pump Removal

Page 15

BRUSH MOTOR REMOVAL

1.Turn off switch and unplug machine.

2.Set the machine in its upright position. Remove the screws (2) in the back metal cover. Rotate the cover down and slide back releasing the tab under the machine from the main frame.

3.Remove the pump box cover. Remove screws

(4) at each leg of the cover.

4.To remove brush motor, position the machine to have access to the bottom. Remove screws (2) at the sides of the machine holding the brush deck pivot axle.

5.Remove screw mounting belt cover and remove belt cover.

6.Remove the nuts and washers (2) at brush motor and slide motor forward to reduce belt tension. Remove belt.

7.Remove pulley by loosening set screw and pull off shaft.

8.Unplug the brush motor wires from the rectifier located in the pump mount housing. Also, remove the ground lug from the stud on the main frame by removing the nut on the stud.

9.Reverse the process to reinstall the motor. Align motor pulley with brush pulley. Check belt for proper belt tension.

MAINTENANCE

PUMP REMOVAL

1.Turn off switch and unplug machine.

2.Set the machine in its upright position. Remove the screws (2) in the back metal cover. Rotate the cover down and slide back releasing the tab under the machine from the main frame.

3.Remove the pump box cover. Remove screws

(4) at each leg of the cover.

4.To remove either pump, loosen the hose clamp and remove the hose from both ends of the pump.

5.Remove screws and washers (4) that mount pump housing.

6.Unscrew the hose fittings from each end of the pump.

7.Flex the pump mounting housing to remove the pump.

8.Remove the screw attaching the ground wire to the pump. Remove the other two wire connectors attached to the pump.

9.Reverse the process to reinstall the pump.

86037780 EXTRACTOR 11/21/07

4-3

Image 15
Contents Mini Carpet Extractor 4 Gallon Overview Machine Data LOG/OVERVIEWTable of Contents HOW to USE this Manual Read ALL Instructions Before Using this Machine SafetyHazard Intensity Level For SafetyVolt Models ElectricalExtension Cords Grounding InstructionsSafety Label Location Operation InspectionChemicals Controls & Components Main Handle Solution ButtonSpecial Notes Operating Instructions Filling the Solution TankOperating the Machine Operating Machine with Accessory ToolsProtect from Freezing MaintenanceDAILY/REGULAR Maintenance Periodic MaintenanceMaintenance Instructions Brush AssemblySpray JET Pump Removal Brush Motor RemovalVacuum Motor Removal Vacuum Motor Carbon Brushes ReplacementProblem Cause Solution Troubleshooting ChartMaintenance Mini Carpet Extractor Parts List Brush Deck Part PRV no QTY Description Serial no From Control Panel Part PRV QTY Description Serial no From Decal LABEL, Control Panel Frame & Wheels BRKT, Brush HOUSING, 10 Handle Part PRV no QTY Description Solution BOX, Pump Mount Extractor 03/22/07 JET, RT ANG, 1/4 Barb Tank & Dome TANK, SOLUTION, Extractor Vacuum VAC MOTOR, 120V 5.7 3ST W/TUBE 115V only Wiring DIAGRAM-CONTROL Panel Wiring Diagram Control Panel Wiring DIAGRAM-VACUUM, Brush Motor & Pump Wiring Diagram VACUUM, Brush Motor & Pump Ground Micro Screw Switch Conductor Wire ASM, 18GA 4 BLK Dash Line = Pump BOX Outline ASM, Filter EMI Brush Hose Diagram Spare Parts AccessoriesExtractor 12/09/06