OPERATION
OPERATING THE MACHINE
1.Vacuum the carpet and make sure it is cleared of surface debris before cleaning.
2.Plug power cord into a grounded wall outlet.
NOTE: Defeating the grounding pin on the power cord can result in a severe electrical shock.
3.Turn on the machine by pressing the switch in the normal operation mode.
NOTE:The vacuum and the brush are protected by circuit breakers located on the control panel, to the right of the switch.
NOTE: If either motor does not respond to being switched on, reset the circuit breakers by pressing them in, and attempt to switch the machine on again.
NOTE: If solution does not dispense in an even pattern across the width of the machine, the spray jet may be clogged. Tilt the machine back, check for debris and clean surface of jet.
NOTE: Do not use pins, wire, etc. to clean spray jet nozzle as this will deform the jet and destroy the spray pattern.
4.While operating machine, check for excessive foam buildup in the recovery tank. If excessive foam is present, add a defoamer solution to recovery tank, or empty tank.
5.Empty recovery tank when approximately 3/4 full. If the recovery tank is overfilled, the water will drain back onto the carpet when the vacuum is switched off.
6.Ventilate area after carpet has been cleaned.
Keep children and pets away and do not walk on carpet until it is dry.
A Windblower™ fan can be used to reduce drying time.
OPERATING MACHINE WITH
ACCESSORY TOOLS
This extractor is easily adapted for use with Windsor accessory tools: Contact Customer Service for details.
1.Disconnect vacuum hose at dome, insert hose cuff into the dome, ensuring that there is a tight fit. Dome must be clamped to recovery tank.
2.Attach the solution hose from accessory tool to the brass solution fitting on the back of machine.
3.Turn on the switch in the accessory position. The application of cleaning solution is now controlled by the lever on the accessory tool.
NOTE: The solution pump is not intended to run dry. When using the extractor for vacuum
CAUTION: This appliance is not suitable for picking up hazardous dust.
86037780 EXTRACTOR 05/09/08 |