E. On Screen Display (OSD) vs. Remote Control Instruction
(1)In Active mode, press the POWER button on the top of receiver or transmitter or press the remote control’s Power button and point it to the receiver or transmitter, both receiver and transmitter will enter Standby mode and transmitter’s HDMI out remains on.
OSD Displays: (Display 3secs and then enter Standby mode.)
ON
(2)Press the INFO button on the remote control to display signal quality, source, channel and resolution information for user reference. Press the INFO button again to exit the
INFO OSD. OSD Displays:
HDMI1 CH1 1280x1024
= OFF
(4)Press the IR button and then the “Up” and “Down” keys on the remote control to change the IR Blaster frequency. The IR frequency can be switched from 47KHz, to 56KHz, and to 38KHz recurring. Note that the IR blaster frequency default setting is 47KHz.
Press once for current IR frequency status display.
HDMI1 CH1 1280x1024
= 47KHz
OSD Displays:
Press IR key again to switch IR blaster frequency.
OSD Displays:
HDMI1 CH1 1280x1024
= 56KHz
(3)Press the SOURCE button on the remote control or on the top of transmitter (or receiver) for audio/ video source input selection. OSD Displays:
HDMI1 CH1 1280x1024
20