IOGear GWHDMS52 user manual

Page 17

4.During warm-up, the transmitter’s and the receiver’s wireless status LED will blink green until the signal link between the transmitter and the receiver is established. It will take approximately 15 ~ 20 seconds for system to fully boot-up successfully.

5. Ensure your TV or projector is in “HDMI input” mode.

17

Image 17
Contents Wireless 5x2 HD Matrix Iogear Part No. M1229-b Table of Contents Important Information Safety PrecautionsSystem Warning Special NoticeRadiation Exposure Statement Using the System in the USFCC Statement French translation Requirements Package ContentsIntroduction Overview Power Adapter DC Wireless status LEDReceiver Video status LEDBattery Compartment Remote ControlInfo Button IR ButtonSetup the Transmitter Hardware InstallationHdtv Connection with receiver Setup the ReceiverIR Blaster Extender cable Blu-ray Player or DVR/Cable Box Mounting the Receiver to a Wall Optional Basic Operation Page Transmitter Source Switch Up/Down arrow buttons LED Info OSD. OSD Displays Perfect companion GKM561R, GKM681R, GKM581R and GKM571R Naming the Input Source Devices Advanced OperationPairing new transmitter with existing receiver optional Multiple Transmitter Selection Setup Return 2D Video Format Timings Resolution Support Supported ResolutionMandatory CEA 3D Video Format Timings Audio Bit Rate SupportInterfaces Transmitter Tx Receiver Rx SpecificationsSolutions TroubleshootingSolution Solutions OSD display TX or/and RX Problem No audio SolutionFederal Communications Commission FCC Statement Limited WarrantyCE Compliance ContactIogear