Windsor ADM8 10080170 manual Troubleshooting Chart, Problem Cause Solution

TROUBLESHOOTING CHART

PROBLEM	CAUSE	SOLUTION
No Power, Nothing	Is the cord plugged in.	Plug in cord.
	Circuit breaker tripped in building.	Reset breaker.
Runs
	Faulty switch.	Call for service.
	Faulty power cord or pigtail.	Call for service.
	Vacuum circuit breaker tripped.	Reset breaker.
Vacuum Motor Will Not	Faulty main vacuum switch.	Call for service.
Run	Loose wiring.	Call for service.
	Faulty vac motor.	Call for service.
	Carbon brushes worn.	See “Brush Replacement” in
		maintenance section.
	Debris lodged in vac shoe.	Remove debris from vac shoe.
Vacuum Motor Runs	Dome gasket defective or missing.	Replace as necessary.
But	.Vacuum hose cracked or hose cuff loose.	Replace or repair as necessary.
Suction Is Poor	Recovery tank full / float ball stuck in the	Turn off vac motor. Drain and rinse
	up position.	recovery tank.
	.Main pump switch off.	Turn on.
Poor Or No Water Flow	Jets clogged or missing.	Clean using a vinegar /water solution or
(Carpet Is Streaky)		replace.
	Solution filter clogged.	Drain solution tank and clean solution
		filter.
	Faulty solenoid.	Call for service.
Brush Does Not Spin	Brush switch off.	Turn on brush switch.
	Brush circuit breaker tripped.	Reset circuit breaker.
	Brush belt broken.	Replace as necessary.
	Faulty brush motor.	Call for service.

4-7 ADMIRAL 86038230