Operation of Vacuum Cleaner

USER MANUAL

ENGLISH

BASIC OPERATION

1 2

1.Check that the electrical switch is switched off,

2.Then connect the suction hose (1) into the suction inlet (2) at the machine by pushing the hose forward until it is sliding in place at the inlet (to release the hose from machine just twist and pull out the hose).

3.Then connect the tubes (1) with the hose handle (2), twist the tubes in order to ensure that they are properly fitted.

4.Attach suitable nozzle (3) to the tube (1), Choose nozzle depending on what type of material that is to be picked-up.

5.Connect the plug into a proper electrical outlet

6.Put the electrical switch (4) into position ”I” in order to start the motor. (GV702 has two motors/fan units and two electrical switches –one switch for each motor).

Dry Operation

The use of a cloth filter bag and a dust bag will improve levels of filtration and is recommended. Always ensure that the container is emptied of any liquid before using for dry pick-up and that the cloth filter is in a clean and dry condition.

Empty the tank when you notice that the performance is reducing or after dry pick-up.

1.Switch off the machine, Release the latches (1) by pulling them outwards so that the motor top (2) is released, and remove the motor top (2).

2.Shake the filter (3) in order to remove debris. This should be done while the hose is still connected to avoid dust exiting from the open dirt container

				connection. After shaking the filter, wait a few moments for the dust to settle.
	2
			1
			1	Remove filter (3) from machine and empty container (4). If the filter’s



				surface appears to be heavily soiled, it is advisable to brush the filter
				material clean with an ordinary soft household brush. This ensures
				continued peak performance.
				3. Having emptied container (4), replace filter (3) and the motor top (2). Make
				sure that the switch/switches is located in direction towards the suction inlet.
4		3
		3

You are now ready to start again.

Wet pick up

The float valve assembly must be used at all times for wet pick-up that shuts off the airflow through the machine when the maximum liquid level is reached.

Always ensure that the container is emptied of any dry dust before using the machine for wet pick-up. Always be sure to use a wet pick-up nozzle with rubber blades.

During wet pick-up operation the floor is left almost entirely dry.

When there is no longer liquid to be collected or the machine is full, switch off the power head, unplug the vacuum

cleaner, empty the container.

Emptying GV25-EU GV35-EU

1.Release the latches (1) by pulling the lower parts outwards so that the motor top (2) is released, Remove the motor top (2).

2.Disconnect the hose (3) from the inlet (4) by screwing the hose outwards.

GV12066(1)2009-01

GV25-EU GV35-EU GV702-EU