Viper VR-6000 owner manual Introduction, General, Certification, About this Manual

Page 7

INSTRUCTIONS MANUAL

INTRODUCTION

GENERAL

Thank you for purchasing a VIPER VR-6000 Air Conditioning Service Center. Your VR-6000 is Underwriters Laboratories Inc.® approved, in compliance with SAE J 2210 (1991). We are dedicated to solving the issues surrounding the safe containment and proper management of CFC’S. Your new VR-6000 incorporates the latest technology and state of the art features to aid you in servicing air conditioning and refrigeration systems. We hope you get as much enjoyment using this equipment as we did designing and building it.

CERTIFICATION

All technicians opening the refrigeration circuit in automotive air conditioning systems must now be certified in refrigerant recovery and recycling procedures to be in compliance with Section 609 of the Clean Air Act Amendments of 1990. For information on certification call MACS Worldwide at (215) 631-7020.

ABOUT THIS MANUAL

This manual includes a SAFETY SUMMARY, machine PREPARATION FOR USE, OPERATION procedures, and MAINTENANCE instructions, for the VIPER VR-6000 Air Conditioning Service Center. Anyone intending to use the VR-6000 should become familiar with ALL the information included in this manual (especially the SAFETY SUMMARY) before attempting to use it.

Before operating this machine for the first time, perform all PREPARATION FOR USE instructions. If your new machine is not properly prepared to perform a service, your service data could be erroneous. In order to properly perform a complete air conditioning service, follow all procedures in the order presented. Please take the time to study this manual before operating the machine. Then keep this manual close at hand for future reference. Please pay close attention to the SAFETY SUMMARY and all WARNINGS and CAUTIONS provided throughout this manual. To activate the published warranty, mail in the attached warranty card.

CAUTION: The VR-6000 is intended for indoor use only.

ABOUT THE VIPER A/C AIR CONDITIONING SERVICE CENTER

The ozone layer around the earth’s atmosphere is a thin protective covering. It acts as a shield against the sun’s destructive ultraviolet rays. Without the ozone layer the very existence of our planet would be in question. Scientific studies show that the ozone layer is being destroyed at an alarming rate. It has been established that emissions from refrigerants, such as R-12, contain chlorofluorocarbons (CFC’s), which are the leading cause of ozone depletion. One CFC molecule has been shown to destroy up to 100,000 ozone molecules. Your VIPER VR-6000 incorporates a highly accurate electronic scale for determining charging weights, etc. Other functions can also be performed with the electronic scale as you will discover during the operating procedures. Either standard or metric units of measure can be selected. Your new VIPER VR-6000 has been designed specifically to use R-134a, to operate within the objectives of the Montreal Protocol.

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents VR-6000 Instructions Manual Index Safety Information Safety SummaryMotion Hazards Electrical Shock HazardsFume Hazards HEAT/FREEZING Hazards Additional Safety InformationEXPLOSION/FLAME Hazards Certification About the Viper A/C AIR Conditioning Service CenterIntroduction GeneralBasic Components MachinePage Control Panel Controls and Control SystemFunction Selector Keyboard Front views Status and Alarm PanelPreparation Measurement SettingViper VR-6000 Specifications Preparation for USEPage Page Operation Instructions Recover and Recycle Refrigerant from AN AC SystemRemoving NON-CONDENSABLE Gases Normal R-134 container pressure chart Recharge AN A/C System Vacuum PhaseRecovering the Refrigerant in the Hoses Replacing Refrigerant FILTER/DRYER MaintenanceCalibrating the Electronic Scale AIR Conditioning Hose MaintenanceEmptying the Used OIL Tank Case CareOil top-up Vacuum PumpPage Refilling does not Flow TroubleshootingRecovery Problems No Display When Main Power Switch is onTo Obtain Services Under this Warranty MANUFACTURER’S Limited WarrantyTransférer Duréfrigérant Neuf Dans LA Bouteille DE Stockage Informations SUR Lasécurité Résumé DES Normes DE SécuritéRisques Liés AU Mouvement Risque DE Décharge ÉlectriqueRisques Liés À LA CHALEUR/AU Froid Risques DE FuméesRisques D’EXPLOSION / Incendie Généralités Informations Supplémentaires SUR LasécuritéInformations SUR CE Manuel Composants Fondamentaux LA MachinePage Tableau de commande Commandes ET VoyantsClavier de sÉlection des fonctions Panneau Voyants ET Alarmes Entrée Mesures Préparation À L’EMPLOIPréparation Page Page RÉCUPÉRATION/RECYCLAGE DE Réfrigérant D’UN Système A/C Instructions Pour LES InterventionsPurge DES GAZ NON Condensables Table pression réservoir R-134 Phase DE VideInjection Huile Neuve Recharge D’UN Système A/CRécupération DU Réfrigérant Dans LES Tuyaux Flexibles Remplacement DES Filtres DéshydrateursManuel D’INSTRUCTIONS Étalonnage DE Labalance Électronique Maintenance DES Tuyaux Flexibles A/CVidange DU Récipient D’HUILE Usée LE Soin DU CASPage Problèmes DE Récupération Vidange huileLE Remplissage NE Circule PAS Remplacement DES Filtres DéshydrateursGarantie Limitée DU Fabricant Pour Obtenir LES Services Prévus PAR Cette GarantieSumario Informaciones DE Seguridad SeguridadPartes EN Movimiento Choque EléctricoHumos Quemaduras Y Congelamiento Información Adicional Sobre SeguridadExplosión E Incendio Acercade Este Manual IntroducciónGeneralidades CertificaciónElementos Fundamentales LA MáquinaPage Panel de control Sistemade Mando Y ControlDescarga DE Aceite Teclado DE Selección DE OperacionesAjuste DE Unidad DE Medida Tablero DE Estado Y AlarmasPreparar LA Bombona DE Almacenamiento DE Refrigerante Puesta EN ServicioDatos DEL Viper VR-6000 PreparaciónPage Page Eliminar Gases no Condensables Fase DE Vacío Tabla de presiones R-134 chartRecargar UN Sistemade A/C Introducir Aceite NuevoRecuperar EL Refrigerante DE LOS Tubos MantenimientoCambiar LOS Filtros Deshidratadores DEL Refrigerante Manual DE Instrucciones Regulación DE Labalanzaelectrónica Vaciar EL Tanque DE Aceite UsadoMantenimiento DEL Caso Mantenimiento DE LOS Tubos DE Aire AcondicionadoReponer aceite Bomba DE VacíoPage Problemas DE Recuperación Resolver ProblemasNo Entra Refrigerante Durante LA Recarga Para Utilizar LOS Servicios DE Esta Garantía Garantía Limitada DEL FabricanteAnual DE Instrucciones Manual DE Instrucciones Wash hands after handling

VR-6000 specifications

The Viper VR-6000 is an innovative addition to the realm of virtual reality headset technology, designed to offer users an immersive and visually stunning experience. Built with meticulous attention to detail, the VR-6000 provides an ideal mix of high-end performance, comfort, and cutting-edge features that cater to both gamers and tech enthusiasts alike.

One of the standout characteristics of the Viper VR-6000 is its high-resolution display. The headset boasts a dual 4K OLED screen that delivers an exceptional pixel density, resulting in incredibly sharp visuals and vibrant colors that breathe life into the virtual environments. This feature significantly enhances the sense of realism, making every gaming session or virtual experience captivating.

The VR-6000 is powered by advanced refresh rate technology, providing a refresh rate of up to 120 Hz. This ensures smooth and fluid visuals, minimizing motion blur and enhancing responsiveness during fast-paced action scenes. Coupled with low-latency tracking, players can enjoy an almost instantaneous response as they move within their virtual space, making the experience feel more natural and engaging.

Comfort is another focal point of the Viper VR-6000 design. The headset has a lightweight frame and adjustable padding, which accommodates prolonged use without discomfort. It is designed to fit a wide range of head sizes, with a customizable strap system ensuring a secure and snug fit. Additionally, the integrated audio system features spatial sound technology that offers 3D audio experiences, allowing users to hear sounds from all directions, further enhancing immersion.

On the technological front, the Viper VR-6000 comes equipped with advanced motion tracking sensors. Utilizing a combination of inside-out tracking and external base stations, it allows for precise movement detection, which is crucial for room-scale VR experiences. Users can move freely within their designated space, and the system accurately reflects these movements in real time.

Compatibility is another highlight of the VR-6000. It supports a wide range of platforms, including both PC and console, allowing users to access an extensive library of VR titles. Moreover, the headset includes easy-to-use connectivity options, such as wireless capability and USB-C support, ensuring seamless integration with various devices.

In summary, the Viper VR-6000 represents a significant leap in virtual reality technology, offering an impressive array of features and capabilities. With its high-resolution display, advanced motion tracking, exceptional comfort, and compatibility with multiple platforms, it stands out as a top choice for those seeking an immersive VR experience. Whether for gaming, simulations, or interactive media, the VR-6000 promises to elevate the way users engage with the virtual world.
Top Page Image Contents