Admiral AAW-10DR3FHU Installation instructions, Select the Best Location, Min. Window Opening

Page 7

Installation instructions

! CAUTION !

Because the compressor is located on the controls side of the unit (right side), this side will be heavier and more awkward to manipulate. Inadequate support on control side of the unit can result in personal injury and damage to your unit and property. Therefore, it is recommended to have someone assist you during the installation of this unit.

1. Select the Best Location

E. Be certain the proper electrical outlet is within reach of the installation. Use only a single outlet circuit rated at proper current (see table 1 on page 4). All wiring should be in accordance with local and national electrical codes.

F. Your unit was designed to evaporate condensation under normal conditions. However, under extreme humidity conditions, excess condensation may cause the basepan to overflow to the outside.

The unit should be installed where condensation run-off cannot drip on pedestrians or neighboring properties.

A. Your room air conditioner was designed to
fit easily into a single or double hung window. However,
since window designs vary, it may be necessary to					Awning
make some modifications for safe and proper				20"
installation.				20"
installation.				Min.
				Min.
B. Make sure window and frame is structurally
sound and free from dry and rotted wood.					12" Min.
					12" Min.
C. For maximum efficiency, install the air conditioner
on side of the house or building which favors more
shade than sunlight. If the unit is in direct sunlight,					20"
it is advisable to provide an awning over the unit.					20"
					Min.
D. Provide sufficient clearance around the cabinet					Fence,
to allow for ample air circulation through the unit.				30" Min.	wall, or
to allow for ample air circulation through the unit.				30" Min.	other
See (Fig.B). The rear of the unit should be outdoors				Side	other
See (Fig.B). The rear of the unit should be outdoors				obstruction	obstacle.
and not in a garage nor inside of a building.
Keep unit as far away as possible from obstacles and				Ground
obstructions and at least 30" above the floor or				Ground
obstructions and at least 30" above the floor or
ground. Curtains and other objects within a room				Fig.B
should be prevented from blocking the air flow.				Fig.B
Window opening requirements
(see table below)
Size	Model	10K	12K	18-24K

	Cabinet size	20.5" 14.8" 23.1" 22.8" 15.7" 24.1" 26.5" 18.5" 26.9"
	(WHD)

	Min. Window	24"	27"	30"
	opening

	Max. Window	38"	41"	44"
	opening

6

Image 7

Contents Room Air Conditioner Table of Contents Part Identification Mechanical control model IntroductionPart Identification Remote control model Electric Shock Hazard Electrical specificationsSee lists below.Fig.A Tips before installationSize Model 10K 12K 18-24K Cabinet size Installation instructionsSelect the Best Location Window opening requirementsPreparation to Remove Air Conditioner Slide-Out Chassis Assembly of the side shutters curtains to the cabinetTOP View Reinstalling Front Panel Assembly Installation of the cabinetSecure Shutters Complete the installation Mode Operating InstructionsElectronic control panel model Buttons How to Use How to Insert the BatteriesAir Filter Removal Care and MaintenanceCleaning the Air Filter Removal of Air Filter Cleaning of Air FilterProblem Possible Cause Suggested Solution Troubleshooting GuideYear Full Warranty WarrantyIdentificaci n de las Piezas Modelo Mec nico Introducci nIdentificaci n de las Piezas Modelo de Remoto controlador Peligro de Descarga El ctrica Especificaciones el ctricasPrecauci N Consejos antes de la instalaci nInstrucciones de Instalaci n Instrucciones de instalaci n Precauci N Instalaci n del gabinete Finalice la instalaci n Precauci N Instrucciones de Operaci nInstrucciones de Operaci n Bot n Mode Modo Control remoto Limpieza del Filtro de Aire Extracci n del Filtro de Aire Cuidado y MantenimientoGu a para la Soluci n de Problemas Garantia Version No