Goldstar DH3010B, DHA4012DL, DHA5012DL, DH5010B, DHA3012DL service manual Rotary Compressor

Page 14

3.3.2 P.T.C. OR OVERLOAD PROTECTOR (O.L.P.) FOR RECIPROCATING COMPRESSOR

1. Remove the cabinet. (Refer to section 3.1.3)

2. Remove a screw or a nut which fastens the terminal cover

3. Disconnect the lead wire from the overload protector or P.T.C. assembly.

4. Remove the overload protector(O.L.P) or P.T.C. assembly. (See Figure 20)

Using Recipro Compressor model

Figure 20

3.3.3 ROTARY COMPRESSOR

1. Remove the cabinet. (Refer to section 3.1.3)

2. Discharge the refrigerant by using a refrigerant Recovery System.

3. After purging the unit completely, unbrace the suction and discharge tubes at the compressor connections.

4. Remove the nuts and washers which fasten the compressor. (See Figure 21)

5. Remove the compressor. (See Figure 21)

Using Rotary Compressor models

Figure 21

— 14—

Image 14

Contents Dehumidifier Contents Preface Safety PrecautionsFeatures DH3010B DH4010B DH5010B SpecificationsModels DHA3012D DHA4012D DHA5012DHOW does the Dehumidifier WORK? HOW to Operate DehumidifierControl Location for the DehumidifierHumidistat Micro SwitchAuto Defrost Capillary is needed. On opening the dryer, itDH3010B Circuit DiagramDescription QTY Location Description QTY PER SET MarksMotor RD DH4010B DH5010BBucket and AIR Filter Disassembly InstructionsMechanical Parts Front Grille Power Cord Assy Rotary SWITCH, Humidisat and Neon Lamp Micro Switch Assy Control PartsFAN and Motor Shroud and BarrierRefrigerating Cycle Rotary Compressor HOW to Replace the Refrigeration System Pulling Vacuum Troubleshooting Guide Possible Causes RemedyCondition Cause Remedy Shuts off the compressor. The fanOr loose, replace the motor. If the motor Exploded View Introduction W0CZZ Model DH4010B/DHA4012DL, DH5010B/DHA5012DLTHERMOSTAT Control DH3010B/DHA3012DL Replacement Parts ListLocation Description Remark W0CZZ Capacitor 4995A20085J 4995A20085G 264110 Memo March