GE ADEHSO Possible Causes What To Do, Doesnotstart, Drythe airas #should, Toomuch, Frostappearson

Page 8

Problem

Possible Causes

What To Do

Dehumidifier

The dehumidifier

• Hake sure the dehumidifier'splug is pushed completely

doesnotstart

is unplugged,

into the outlet.

 

The fuse is blown/circuit

, Check the house fuse/circuit breaker box and replace

 

breaker is tripped,

the fuse or resetthe breaker.

 

Dehumidifier has reached its

The dehumidifier automatically turns off when either

 

preset

level or bucket is full.

condition occurs. Change to a lower setting or empty

 

 

 

the bucket and replace properly.

 

Bucket

is not in the

• The bucket must be in place and securely seated for the

 

proper

position,

dehumidifier to operate.

 

Power failure.

• There is a protective time delay (up to 3 minutes) to

 

 

 

prevent tripping of the compressor overload. For this

 

 

 

reason,the unit may not start normal dehumidifying

 

 

 

for 3 minutes after it is turned back on.

Dehumidifier doesnot

Did not allow enough time

,,When first installed, allow at least 24 hours to maintain

drythe airas #should

to remove the moisture,

the desired dryness.

 

Airflow

is restricted.

• Hake sure there are no curtains, blinds or furniture

 

 

 

blocking the front or back of the dehumidifier. Seethe

 

 

 

Choosinga Location section.

Dirty filter.

The Humidity Control may not be set low enough,

Doors and windows may not be closed tightly,

Clothes dryer may be blowing moisture-laden air into the room.

Room temperature is too low.

,Seethe Careand Cleaningsection.

For drier air, pressthe T pad and set to a lower percent

value (%)or at CO(continuous)for maximum dehumidification.

Check that all doors,windows and other openings are securely closed.

Install the dehumidifier away from the dryer. The dryer should be vented to the outside.

Hoisture removal is best at higher room temperatures. Lower room temperatures will reduce the moisture removal rate. Models are designed to be operated at temperatures above 41°F (5°C).

Dehumidifier runs

Area to be dehumidified

 

* The capacity of your dehumidifier may not be adequate.

toomuch

istoo large.

 

 

 

 

 

Doors and windows are open.

* Closeall doors and windows to the outside.

Frostappearson

Dehumidifier

has been turned

* This is normal. Frostwill usually disappear

the coils

on recently, or room temperature

within 60 minutes. Seethe Automatic Defrostsection.

 

is below 41°F(5°C).

 

 

Controls cannot be set

The

compressor

will turn

off

• This is normal. Wait approximately 3 minutes and set the

 

and

the fan

will

automatically

fan as desired.

 

continue to

run

for

 

 

 

approximately

3 minutes

at o

 

 

fixed setting.

 

 

 

 

Fan noise

Air

is moving through

 

"This is normal.

 

the

dehumidifier.

 

 

 

Water on floor

Hose connection

may be loose.

• Check the hose connection. Seethe RemovingCollected

 

 

 

 

 

 

Water section.

 

Intended to use the bucket to

• Disconnect the hose if using the bucket to collect water.

 

collect water, but e hose

 

Seethe RemovingCollected Water section

 

us attached.

 

 

 

 

Bucket FullLEDlight

Drain hose not tight on fitting

• Check drain hose connection.

flashingand alarm

 

 

 

 

 

 

sounds while drainhose

Drain hose is kinked

 

• Ensurethe drain hose is pointed straight down to the floor

is connected

 

 

 

 

 

and is not kinked in anyway.

8

Image 8
Contents Model # Serial # Troubleshooting49-7619-1 12-09GE IMPORTANTSAFETYINFORMATION. Readall iNSTRUCTiONSBEFOREUSING Do not use an adapter plug with this applianceUseofextensioncords GEAppliance&comFan Speed Pad Delay OffAbout the controlson the dehumidifier Usingthedehumidifier How the Behumidifier OperatesAutomatic Defrost Choosing a LocationUsingthe dehumidifier Water LevelThebucket mustbe replaced in the proper position Proper positionCareandcleaningof thedehumidifier Grille and CasePossible Causes What To Do DoesnotstartDrythe airas #should ToomuchOwhershjpregjstratjoh ONTARIO,L4Y461 GEAppliances.com We Will Replace We Will Replace Entretien Nettoyage SerieInscrivez ici les humerus de modele et de Numem de modele Numem de SerieNuti/isez PAS dadaptateurs avec cet apparel Conservezcesinstructions Proposdes commandosdu d .shumidificateur CompteurhorairedufiltreAffichage Touchesdereglagede IhumiditeChoix dun Emplacement UtilisationdudeshumidificateurFonctionnement flu B#shumidificateur #givrage Automatique Nutilisezpas le deshumidificateur IexterieurNiveau dEau Retrait de/Eau Co//ect#e×tr6mit6 au niveau du siphon de sol SeauMiseen Garbe ai,MSs Entretienet nettoyagedu d#shumidificateurGrille et Bo#ier Filtre a AirOwnershipregjstratjoh Andto aflowforefficientcommunicalbnundertheterms Conseilsde d#pannage El=,rome,agersge.ca Probl#meCauses Possibles Que faireDeshumidificateur GE Garantie LimiteeDun An Dachatinitial Dur6e de Igrntie dorigineduninServicea/a clientele Site IntemetGEAcerca Los controles C6mo El agua Acumulada C6mo Funciona El deshumedificadorAutomdtico Nivel de agua Selecci6n Del Lugar adecuado Producto con la etiqueta ENERGYSTAR/EIADVERTENCIA B4sicas de seguridad, incluyendoComoconectarlaelectricidad No USEun enchufe adaptador con este aparatoRetarde en apagade Delay Off Pcerca de los controlesde/deshumedificador CEArplianoe .oomBotonesparael Controlde humedad FanSpeedC6mo usar el deshumedificador Comofunciona el deshumedificador Descongelado automaticoSeleccion de/lugar adecuado No use el deshumedificadoren exterioresHay 2 formasde desechar el agua acumulada Como desechar el agua acumuladaNivel de agua Cuidadoy limpiezade/deshumedificador PRECAUCIONNo elReji//a y gabinete TanquedeaguaLa luzLEDde Tanque Uene destellay suenala alarma Ideaspara la identificaci6ny soluci6n depmblemasEldeshumedificador noenciende Causaspesibles Qu6hater HacemideGarantia de su deshumedificador--garantialimitada de un afio Piezos y occesorios ConsumerSupport GEAppliancesWebsite

ADERSO, ADEHSO specifications

GE ADEHSO (Advanced Electrical High-Density Switching Optimization) and ADERSO (Advanced Distributed Energy Resource Switching Optimization) are cutting-edge technologies developed by General Electric to address the evolving challenges in energy management and distribution. These systems are specifically designed to enhance the efficiency, reliability, and performance of electrical grids, particularly in a landscape where renewable energy and distributed generation sources are becoming more prevalent.

One of the main features of GE ADEHSO is its ability to optimize the switching operations in high-density electrical networks. It utilizes advanced algorithms and machine learning techniques to analyze real-time load conditions, allowing for dynamic reconfiguration of the network. This capability not only enhances the resilience of the grid but also minimizes downtime and enhances service reliability, thereby reducing operational costs for utilities.

ADERSO complements ADEHSO by focusing on distributed energy resources (DERs). With the increasing integration of solar panels, wind turbines, and battery storage systems, the need for sophisticated management of these resources has never been more critical. ADERSO provides a comprehensive framework for coordinating and optimizing DERs to ensure that they are utilized effectively while maintaining grid stability. It facilitates peer-to-peer energy trading and enhances demand response initiatives, contributing to a greener energy landscape.

Both ADEHSO and ADERSO utilize the Internet of Things (IoT) technologies to create smart grid systems. By leveraging IoT sensors and devices, these systems can gather and process data from various sources, providing utilities with unprecedented insights into grid operations. This data-driven approach allows for proactive maintenance and quicker response to potential outages or system failures.

In terms of characteristics, GE ADEHSO and ADERSO are designed to be scalable and adaptable. They can be integrated into existing grid infrastructures without significant overhauls, making them suitable for a wide range of applications—from urban centers to remote areas. Furthermore, their user-friendly interfaces allow operators to easily interact with the systems, facilitating intuitive management of complex energy networks.

In summary, GE ADEHSO and ADERSO represent a significant advancement in energy distribution and management technologies. By enhancing switching operations and optimizing the integration of distributed energy resources, these systems not only improve grid reliability but also play a crucial role in advancing the global transition towards sustainable energy sources.