C |
F |
T |
S |
Fig. 5.2 |
BURNERS AND GRIDS
✓These parts can be removed and cleaned with appropriate products.
✓After cleaning, the burners and their flame distributors must be well dried and cor- rectly replaced.
✓It is very important to check that the burner flame distributor and the cap has been correctly positioned - failure to do so can cause serious problems.
✓In appliances with electric ignition keep the electrode clean so that the sparks always strike.
✓Note: To avoid damage to the electric ignition do not use it when the burners are not in place.
CORRECT REPLACEMENT OF THE BURNERS
It is very important to check that the burner flame distributor F and the cap C has been correctly positioned (see figs. 5.2 and 5.6 ) failure to do so can cause serious problems. Check that the electrode “S” (fig. 5.2) is always clean to ensure
Check that the probe “T” (fig. 5.2) next to each burner is always clean to ensure cor- rect operation of the safety valves.
Both the probe and ignition plug must be very carefully cleaned.
Fig. 5.3
TRIPLE RING BURNER
The triple ring burner must be correctly positioned (see fig. 5.3); the burner rib must be enter in their logement as shown by the arrow.
Then position the cap A and the ring B (fig. 5.4 - 5.5).
The burner correctly positioned must not rotate (fig. 5.4).
A B
Fig. 5.4
30
Fig. 5.5 | Fig. 5.6 |