Heat & Glo LifeStyle SUPREME-XTS, GRAND-XTS owner manual Log Set Assembly LOGS-GXT

Page 24

If the gas logs have been factory installed they should not need to be positioned. If the logs have been packaged separately, refer to the following instructions.

CAUTION: Logs are fragile! Carefully remove the logs from the packaging.

1

4 5 6 7

2 3

Log Set Assembly: LOGS-GXT

PILOT

BRACKET BURNER BASEPAN

TAB

TAB

GRATE

Carefully remove the logs from the packaging. CAUTION: Logs are fragile!

1

1

LOG #1 (SRV339-701):Place log #1 in the back on the insert. Locate the left end of the log over the center of the pilot and the back side of the left end flush with the back of the pilot bracket. Pull the right end of the log forward until it touches the tab in the base pan.

2

2

LOG #2 (SRV339-702):Position log #2 by locating its slot over the tab on the front left of the burner. The slot in the left side of log #2 fits over the bar grate.

339-935 2/02

24

Heat & Glo • Supreme-XTS, Grand-XTS349-901 Rev. i • 12/09

 

Image 24
Contents Models Supreme-XTS Grand-XTS What to do if you smell gasCongratulations Homeowner Reference InformationTable of Contents Listing and Code Approvals Design and Installation Considerations Getting StartedTools and Supplies Needed Inspect Appliance and ComponentsFireplace Size Requirements Minimum Fireplace OpeningClearances Clearances to Mantels or other Combustibles above ApplianceTermination Locations Vent Termination Minimum ClearancesVent Information and Diagrams Vent Table KeyHorizontal Venting Measuring StandardsInstallation Preparation Installing Vent Pipe and Appliance Connecting Vent PipeVenting Components Placing, Securing and Leveling the Appliance Installing Adaptor and Termination Cap Factory Built Wood BurningDamper Flashing Kit Optional Gas Information Fuel Conversions Gas ConnectionGas Pressures High Altitude Installations Wiring the Appliance ON/OFF SwitchElectrical Information Appliance RequirementsJunction Box Installation Optional AccessoriesFAN Junction BOX Finishing Mantel ProjectionsAppliance Setup Clean the ApplianceAccessories Ember PlacementLog Set Assembly LOGS-SXT Positioning the LogsHeat & Glo Supreme-XTS, Grand-XTS 349-901 Rev. i 12/09 Heat & Glo Supreme-XTS, Grand-XTS 349-901 Rev. i 12/09 Log Set Assembly LOGS-GXT Heat & Glo Supreme-XTS, Grand-XTS 349-901 Rev. i 12/09 Heat & Glo Supreme-XTS, Grand-XTS 349-901 Rev. i 12/09 Glass Assembly Air Shutter SettingOperating Instructions Before Lighting ApplianceBefore operating this appliance have a qualified technician Lighting Appliance Standing Pilot IgnitionInitial Break-in Procedure Check Pilot Flame AppearanceAfter Appliance is Lit Frequently Asked Questions Issue SolutionsTroubleshooting Symptom Possible Causes Corrective ActionStanding Pilot Ignition System Troubleshooting Symptom Possible Cause Corrective ActionMaintenance Tasks Maintaining and Servicing ApplianceInspect Maintenance Tasks Doors, SurroundsAppliance Dimension Diagram Reference MaterialsVent Kits Components Direct Vent Flex Liner KitsLimited Lifetime Warranty Heat & Glo Supreme-XTS, Grand-XTS 349-901 Rev. i 12/09 Contact Information