Heat & Glo LifeStyle GRAND-XTS, SUPREME-XTS Log Set Assembly LOGS-SXT, Positioning the Logs

Page 21

E. Positioning the Logs

If the gas logs have been factory installed they should not need to be positioned. If the logs have been packaged separately, refer to the following instructions.

CAUTION: Logs are fragile! Carefully remove the logs from the packaging.

Log Set Assembly: LOGS-SXT

1

4

3

2 6

5

PILOT BURNER BASEPAN

GRATE

TABS

1

1

LOG #1 (SRV349-701):Place log #1 in the back of the insert. Locate the legs of the log outside the 3/8" tabs to either side of the burner. Pull the log forward until the log is stopped by the back edge of the burner.

349-935 1/02

Heat & Glo • Supreme-XTS, Grand-XTS • 349-901 Rev. i • 12/09	21

Image 21

Contents What to do if you smell gas Models Supreme-XTS Grand-XTSHomeowner Reference Information CongratulationsTable of Contents Listing and Code Approvals Getting Started Design and Installation ConsiderationsTools and Supplies Needed Inspect Appliance and ComponentsMinimum Fireplace Opening Fireplace Size RequirementsClearances to Mantels or other Combustibles above Appliance ClearancesVent Termination Minimum Clearances Termination LocationsVent Table Key Vent Information and DiagramsHorizontal Venting Measuring StandardsInstallation Preparation Installing Vent Pipe and Appliance Connecting Vent PipeVenting Components Placing, Securing and Leveling the Appliance Installing Adaptor and Termination Cap Factory Built Wood BurningDamper Flashing Kit Optional Gas Information Fuel Conversions Gas ConnectionGas Pressures High Altitude Installations ON/OFF Switch Wiring the ApplianceElectrical Information Appliance RequirementsOptional Accessories Junction Box InstallationFAN Junction BOX Mantel Projections FinishingClean the Appliance Appliance SetupAccessories Ember PlacementPositioning the Logs Log Set Assembly LOGS-SXTHeat & Glo Supreme-XTS, Grand-XTS 349-901 Rev. i 12/09 Heat & Glo Supreme-XTS, Grand-XTS 349-901 Rev. i 12/09 Log Set Assembly LOGS-GXT Heat & Glo Supreme-XTS, Grand-XTS 349-901 Rev. i 12/09 Heat & Glo Supreme-XTS, Grand-XTS 349-901 Rev. i 12/09 Air Shutter Setting Glass AssemblyOperating Instructions Before Lighting ApplianceBefore operating this appliance have a qualified technician Standing Pilot Ignition Lighting ApplianceInitial Break-in Procedure Check Pilot Flame AppearanceAfter Appliance is Lit Issue Solutions Frequently Asked QuestionsTroubleshooting Symptom Possible Causes Corrective ActionStanding Pilot Ignition System Symptom Possible Cause Corrective Action TroubleshootingMaintaining and Servicing Appliance Maintenance TasksDoors, Surrounds Inspect Maintenance TasksReference Materials Appliance Dimension DiagramDirect Vent Flex Liner Kits Vent Kits ComponentsLimited Lifetime Warranty Heat & Glo Supreme-XTS, Grand-XTS 349-901 Rev. i 12/09 Contact Information