Desa GG30P, FG30P, GG30N, FG30N Attaching To Wall Anchor Method, Placing Heater On Mounting Bracket

Page 10

INSTALLATION

Continued

2.Mark screw locations on wall (see Figure 8).

Note: Only mark last hole on each end of mounting bracket. Insert mounting screws through these holes only.

3.Remove tape and mounting bracket from

12"

14"

Min.

 

WallAdjoining

Only Insert Mounting

32"

Screws Through Last

 

Min.

 

Hole On Each End

 

 

Floor

Figure 8 - Mounting Bracket Clearances

Attaching Mounting Bracket To Wall Note: Wall anchors, mounting screws and spacers are in hardware package. The hardware package is provided with heater.

Attaching To Wall Stud Method

For attaching mounting bracket to wall studs

1.Drill holes at marked locations using 9/64" drill bit.

2.Place mounting bracket onto wall. Line up last hole on each end of bracket with holes drilled in wall.

3.Insert mounting screws through bracket and into wall studs.

4.Tighten screws until mounting bracket is

firmly fastened to wall studs.

Attaching To Wall Anchor Method

For attaching mounting bracket to hollow walls (wall areas between studs) or solid walls (concrete or masonry)

1.Drill holes at marked locations using 5/16" drill bit. For solid walls (concrete or masonry), drill at least 1" deep.

2.Fold wall anchor as shown in Figure 9.

3.Insert wall anchor (wings first) into hole. Tap anchor flush to wall.

4.For thin walls (1/2" or less), insert red key into wall anchor. Push red key to “pop” open anchor wings. IMPORTANT: Do not hammer key! For thick walls (over 1/2" thick) or solid walls, do not pop open wings.

5.Place mounting bracket onto wall. Line up last hole on each end of bracket with wall anchors.

6.Insert mounting screws through bracket and into wall anchors.

7.Tighten screws until mounting bracket is firmly fastened to wall.

Figure 9 - Folding

Figure 10 - Popping

Anchor

Open Anchor Wings

 

For Thin Walls

Placing Heater On Mounting Bracket

1.Locate two horizontal slots on back panel of heater.

2.Place heater onto mounting bracket. Slide horizontal slots onto stand-out tabs on mount- ing bracket.

Horizontal Slots

Stand-

Out Tab

Mounting Bracket (attached to wall)

Figure 11 - Mounting Heater Onto

Mounting Bracket

10

www.desatech.com

114683-01B

Page 9 Page 11
Image 10
Page 9 Page 11
Contents What to do if YOU Smell GAS Table of Contents Safety Information Poisoning may lead to deathLocal Codes Product FeaturesUnpacking Following are excerpts from National Fuel AIR for Combustion VentilationProviding Adequate Ventilation Unusually Tight ConstructionDetermining FRESH-AIR Flow for Heater Location Determining if You Have a Confined or Unconfined SpaceCheck GAS Type InstallationVentilation AIR Ventilation Air From Inside BuildingInstallation Items Locating HeaterMounting Bracket Installing Heater to WallThermostat Sensing Bulb Thermostat Models Only Removing Front Panel Of HeaterAttaching To Wall Anchor Method Placing Heater On Mounting BracketInstalling Bottom Mounting Screws Installing Bottom Mounting ScrewsConnecting to GAS Supply Typical Inlet Pipe DiameterPsig 3.5 kPa Checking GAS ConnectionsTest Pressures Equal To or Less Than EquipmentOpen equipment shutoff valve see , Make sure control knob of heater is in the OFF positionOperating Heater Manual Control Models For Your Safety Read Before LightingLighting Instructions Shutting Off Heater Manual Lighting ProcedureTo Turn OFF GAS To Appliance Shutting Off Burner Only pilot stays litThermostat Control Operation Burner Flame Pattern Inspecting HeaterPilot Flame Pattern Check pilot flame pattern and burner flame pat- tern oftenBurner Pilot AIR Inlet Cleaning MaintenanceODS/PILOT and Burner CabinetTroubleshooting Observed Problem Possible Cause RemedyDelayed ignition of burner Manifold pressure is too low Out when control knob is re Control knob not pressedSafety interlock system has Burner orifice is clogged Clean burner see CleaningTurning control knob to Or shut off Qualified service personOperation Processes Hours of operation Air passageways on heaterGas leak. See Warning Statement aboveBG30N, FG30N, GG30N, RG30N, GMG30N SpecificationsBG30P, FG30P, GG30P, RG30P, GMG30P Service Publications Replacement Parts Service HintsTechnical Service Parts Under WarrantyIllustrated Parts Breakdown Parts List NJF 8CIllustrated Parts Breakdown NJF 8C FAN Kits GA3250T AccessoriesEquipment Shutoff Valve GA5010 For all models. Equipment shutoff valve with 1/8 NPT tapParts Centrals Keep this Warranty Warranty InformationLimited Warranty VENT-FREE Residential GAS Heaters
Top Page Image Contents