Desa T, V installation manual Logs, pages 15

12

INSTALLATION

Installing Heater Base Assembly (Cont.)

INSTALLATION

Continued

4.	Place logs in their proper position on heater base (see Installing
	Logs, pages 15 and 16).
5.	Center heater base and logs front-to-back and side-to-side in
	fireplace.
6.	Carefully remove logs without moving heater base.
7.	Mark screw locations through one hole on each side of the
	mounting bracket (see Figures 13, 14 or 15, depending on your
	model). If installing in a brick-bottom fireplace, mark screw
	locations in mortar joint of bricks.
8.	Remove heater base from fireplace. If installing optional con-
	trol accessories, do so at this time (Remote-Ready Models
	Only). Follow all directions provided with accessory.
9.	Drill holes at marked locations using 3/16" drill bit.

VINTAGE OAK LOG CHASSIS

(Variable Manually-Controlled and

Thermostat-Controlled Models)

Masonry

Screw

Bracket with

Screw Holes

10. Attach base assembly to fireplace floor using two masonry

screws (in hardware package).

Heater Gas

Regulator

Fitting

Flexible Gas Hose (if allowed by local codes)

Figure 11 - Attaching Flexible Gas Hose to Heater Gas Regulator (Variable Manually-Controlled and Thermostat- Controlled Models Only)

Flexible Gas Hose (if allowed by local codes)

Fitting

Figure 13 - Attaching Heater to Fireplace Floor (Variable Manually- Controlled and Thermostat-Controlled Models Only)

Masonry

Screw

GOLDEN OAK AND
BIRCH MODEL CHASSIS
(Variable Manually-Controlled and	Bracket with
Thermostat-Controlled Models)
	Screw Holes

Figure 14 - Attaching Base to Fireplace Floor (Remote-Ready Models Only)

Masonry

Screw

Figure 12 - Attaching Flexible Gas Hose to Heater (Remote-

Ready Models Only)

GOLDEN OAK AND BIRCH MODEL CHASSIS (Remote-Ready Models)

Bracket with Screw Holes

Figure 15 - Attaching Base Assembly to Fireplace Floor

For..com

107070-01F