Fisher & Paykel OR24SDMBGX Injectors Table, Setting the Burner Minimum Valves may vary

b2

J

Fig. 2.7

INJECTORS TABLE

	NOMINAL	REDUCED	LP/PROPANE	NATURAL GAS
	POWER	POWER	11” W.C.P.	4” W.C.P.
BURNERS	BTU/hr	BTU/hr	Ø injector	Ø injector
			[1/100 mm]	[1/100 mm]
Auxiliary (AUX)	3500	1000	55	90
Semirapid (SR)	6000	1500	72	118
Triple ring (TC)	12000	5000	102	170
Oven burner	13000	1500	109	180
Broil burner	8500	-	88	146

J

Fig. 2.8

OPERATIONS TO BE PERFORMED WHEN SUBSTITUTING THE INJECTORS

✓Remove the gratings, the burner covers and the knobs;

✓Using a wrench substitute the nozzle injectors “J” (figs. 2.7 - 2.8) with those most suitable for the kind of gas for which it is to be used.

The burner are conceived in such a way so as not to require the regulation of the primary air.

Regulation screw

Fig. 2.9a

OR

regulation screw

Fig. 2.9b

SETTING THE BURNER MINIMUM (Valves may vary)

When switching from one type of gas to another, the minimum flow rate must also be correct: the flame should not go out even when passing suddenly from maximum to minimum flame.

To regulate the flame follow the instructions below:

–Light the burner

–Set the gas valve to LO position

–Remove the knob

–With a thin screwdriver, turn the regulation screw (Figs. 2.9a and 2.9b) until adjustment is correct. On some valves, you need to pass by the hole of the microswitch (Fig. 2.9a) to turn the regulation screw.

For LP/PROPANE gas, tighten the regulation screws completely.

14