Fisher & Paykel OR24SDMBGX Electrical connection, Recommended ground method

Page 17

electrical connection

33

If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate.

Check with a qualified electrician if you are not sure whether the range is properly grounded.

Do Not ground to a gas pipe.

A 120-volt, 60-Hz, AC-only, 15-ampere, fused electrical supply is required. A time-delay fuse or circuit breaker is recommended. It is recommended that a separate circuit serv- ing only this appliance be provided.

The outlet must be checked by a qualified electrician to see if it is wired with correct polarity.

This appliance, when installed, must be electrically grounded in accordance with local codes.

Recommended ground method

For your personal safety, this range must be grounded. This range is equipped with a 3-prong ground plug. To minimize possible shock hazard, the cord must be plugged into a mating 3-prong ground-type outlet, grounded in accordance with the National Electrical Code ANSI/NFPA 70 latest edition and local codes and ordinances. If a mat- ing outlet is not available, it is the personal responsibility and obligation of the customer to have a properly polarized and grounded, 3-prong outlet installed by a qualified electrician.

WARNING

Electrical Shock Hazard

Plug into a grounded 3-prong outlet.

Do not remove ground prong. Do not use an adapter.

Failure to follow these instructions can result in death, fire, or electrical shock.

3-prong

3-prong polarized

ground-type outlet

ground plug

 

power

supply cord

ground

prong

Fig. 3.1

WARNING

VERY IMPORTANT

Before any operation of maintenance disconnect the appliance from the electrical mains supply.

17

Image 17 Contents
Installation instructions Instructions dinstallation ALL Ranges can TIP For Installer only Installation Instructions Electrical Grounding Instructions Replacement PartsElectrical Requirement Air Supply and VentilationGAS and Electric Connection InstallationProximity to Side Cabinets Assembling the Backguard It is mandatory to install the backguardLevelling the Range ANTI-TIP Stability Device Installation InstructionsManual Shut-off Valve fig Gas connectionExplosion Hazard Pressure RegulatorPressure Regulator Installation Step Connector GAS Connection SpecificationRigid Pipe Connections Leak TestingFlexible Connections To set the pressure regulator Setting the Pressure Regulator .6b Conversion to LP/PROPANE GAS Injectors Table Operations to be Performed When Substituting the InjectorsSetting the Burner Minimum Valves may vary Broil Burner Oven BurnerAdjustment of the Oven Burner Minimum Recommended ground method Electrical connectionWiring Diagram Page Avertissement ’INTENTION DE L’INSTALLATEUR Seulement Avertissement Instructions D’INSTALLATIONPièces DE Rechange Instructions DE Mise À LA TerreExigences électriques Alimentation d’air et ventilationRaccordements Électrique ET AU GAZ A1installationProximité DES Armoires Montage DU Dosseret ’installation du dosseret est obligatoireMise À Niveau DE LA Cuisinière Robinet d’arrêt manuel fig Raccordement au gazRégulateur de pression Risque d’explosionFermer Installation DU Régulateur DE Pression ÉtapeJoint Spécification DU Raccordement AU GAZVérification de l’absence de fuite Raccords flexiblesRaccords de tuyaux rigides Pour régler le régulateur de pression Conversion AU GAZ PROPANE/GPLRéglage DU Régulateur DE Pression .6b Réglage Minimum DU Brûleur Les robinets peuvent varier Tableau DES InjecteursOpérations À Effectuer Pour Remplacer LES Injecteurs Brûleur du gril Brûleur du fourRée Réglage Minimum DU Brûleur DU FourRaccordement électrique Méthode de mise à la terre recommandéeSchéma DE Câblage Page Page Page US CA
Related manuals
Manual 48 pages 52.98 Kb