Hookup and Installation
Step 10
Connect your Cable TV/Satellite Coaxial Lines
Your PureAV Power Console comes with two pairs of F-type coaxial- cable connections, and one pair of aerial-cable connections to protect your system from dangerous electrical disturbances that can travel down your cable/satellite/aerial-signal lines. You will need additional coaxial cables to connect the Power Console to your home cinema components.
A. Satellite (DSS) TV – Connect the incoming satellite television F-type coaxial-cable line to the connector labeled “SAT IN”. Connect one end of a second coaxial cable to the connector labeled “SAT OUT”. Connect the other end of this cable to your satellite TV tuner.
B.Cable TV – Connect the incoming cable television F-type coaxial-cable line to the connector labeled “Cable IN”. Connect one end of a second coaxial cable to the connector labeled “Cable OUT”. Connect the other end of this cable to your cable TV set-top box.
C.Antenna – Connect the incoming TV or radio antenna cable line to the connector labeled “Antenna IN”. Connect one end of a second aerial cable to the connector labeled “Antenna OUT”. Connect the other end of this cable to your TV or radio equipment.
Note: We have included labels for the “Coax IN” and “Coax OUT” lines, if needed, for better organisation.
IMPORTANT WARNING: To sufficiently safeguard all of your equipment from damage resulting from a power surge, all of your incoming coaxial-cable lines should be properly earthed. Contact a licensed electrician to verify that all of your cable lines are properly earthed to a cold water pipe or earth rod.
