•Next to or directly above heaters or air conditioning vents, windows, wall vents etc. that can change the direction of airflow and cause rapid temperature fluctuations.
•In very high or awkward areas (e.g. over stairwells) where it may be difficult to reach the unit (for testing, hushing etc.).
•Locate away from very dusty or dirty areas as dust
•Locate the unit at least 1m from dimmer controlled lights and wiring as some dimmers can cause interference.
•Locate the unit at least 1.5m and route wiring at least 1m away from fluorescent light fittings as electrical “noise” and/or flickering may affect the unit. Do not wire into the same circuit as fluorescent lights or dimmers.
•Do not locate in insect infested areas. Small insects getting into the optical sensor chamber can cause intermittent alarms. Insects and contamination on the heat sensor can increase its response time.
5. INSTALLATION
The Alarm is designed to be permanently mounted, using it’s own
IMPORTANT PRECAUTION: Do not install alarms in new or renovated buildings until all work is completed (including floor coverings) and the building has been
17