C. Sidewalls/Surrounds
•Adjacent combustible sidewalls must be located a minimum of 12 in. (305 mm) from the fireplace opening.
•Combustible and noncombustible mantel legs, surrounds and stub walls may be constructed within the gridded area, Figure 6.3.
10 3/4 in.
[273 mm]
FLUSH
FRONT
50° | angle |
|
12 in.
[305 mm]
4 in.
BRICK [102 mm]
FRONT
36 in.
[914 mm]
39° | 14 1/2 in. | |
angle | ||
[368 mm] |
42 1/8 in.
[1070 mm]
12 in.
[305 mm]
Figure 6.3 Mantel Leg or Wall Projections (Acceptable on both sides of opening)
D. Frame the Fireplace
Figure 6.4 shows typical framing using combustible materials (2x4 lumber shown).
•Observe all required air space clearances to combustible materials as shown in Figure 6.1 & 6.2.
•Framing across the top of fireplace must be above top standoffs.
2 in. (51 mm) min. air space clearance from chimney.
Note: Framing must be extended straight up, all the way to the ceiling.
| Header MUST NOT be notched! |
|
|
|
| ||
| D = extra space needed for outside air connection. |
|
|
|
| ||
C | If outside air duct has no bend, this dimension may be |
|
|
|
| ||
reduced as long as minimum clearances are met. |
|
|
|
| |||
|
|
|
|
| |||
| D |
|
|
|
| ||
| A |
|
|
|
| ||
| B |
|
|
|
|
|
|
| Model | A | B* | C** | D | ||
|
| ||||||
|
| SC60 | in. | 43 1/8 | 25 | 41 1/4 | 8 |
|
|
|
|
|
|
| |
|
| mm | 1095 | 635 | 1048 | 203 | |
|
|
| |||||
* If interior of chase will be drywalled, add the thickness to this measurement.
** Adjust header height for a raised floor under fireplace.
Figure 6.4 Framing the Fireplace
20 | Heatilator • SC60 • 32838 • Rev Y • 11/08 WIP |