Hearth and Home Technologies I60 owner manual Install the Refractory I80 only, GAS Knockout

F. Install the Refractory (I80 only)

We recommend two installers for hearth stone and refrac- tory installation!

•Set back refractory into place, making sure refractory is centered and notches are to the bottom of firebox.

•Place grate brackets in outer two notches of refractory. See Figure 7.9.

•Secure back refractory in place with a screw and bracket supplied in hardware package. See Figure 7.10.

GRATE BRACKETS

Figure 7.9 Back Refractory with Grate Brackets in Place

REFRACTORY

BRACKET

Figure 7.10 Attaching Back Refractory

Note: To ensure proper installation, gas knockouts in the side refractory should be positioned towards back of fireplace. See Figure 7.11.

GAS

KNOCKOUT

Figure 7.11 Gas Knockout

•Tilt top of side refractory towards center of firebox when placing it into fireplace. Push side refractory towards back corner of fireplace until it fits tightly against back refractory.

•Secure side refractory in place with a screw and bracket provided in the hardware package.

•Repeat these two steps for installation of the other side refractory.

•When placing hearth stone into fireplace, slide it back until it fits tightly against back refractory (underneath grate brackets). See Figure 7.12.

GRATE

BRACKET

Figure 7.12 Sliding Bottom Refractory Towards

Back of Fireplace

•Place grate into grate brackets. See Figure 7.13.

•Replace smoke shield.

GRATE

BRACKET

Figure 7.13 Grate Secured in Grate Bracket

•Replace left and right screens.