Hearth and Home Technologies QV26E Listing and Code Approvals, Certification, Fire Risk

Page 4

1Listing and Code Approvals

A. Certification

This heater has been tested in accordance with the UL2021 Standards for fixed and location-dedicated electric room heaters in the United States, the current CSA C22.2 No. 46 in Canada and has been listed by Underwriters Laboratories Inc. for installation as described in this manual. All compo- nents are UL or CSA safety certified.

This heater has been tested and listed for use with the op- tional components specified in this manual. These optional components may be purchased separately and installed at a later date.

Quadra-Fire is a registered trademark of Hearth & Home Technologies Inc.

WARNING

Fire Risk

Do not install or operate damaged heater.

Do not modify heater.

Installation other than as instructed by Hearth & Home Technologies Inc. is strictly prohibited.

Do not operate the heater without fully assembling all components.

Installation and/or use of any component part not approved by Hearth & Home Technologies.

Hearth & Home Technologies disclaims any responsibility for, and the warranty and agency listing will be voided by the above actions.

B. Important Instructions

When using electrical heaters, basic precautions should al- ways be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:

Read all instructions before using this heater.

This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 12 in. (305 mm) from the front of the heater and keep them away from the sides and rear.

Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.

Always unplug heater when not in use.

Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. Return heater to authorized service facility for examination, electrical or mechanical adjustment, or repair.

WARNING

Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to the owner’s information manual provided with this heater. For assistance or additional information consult a qualified installer, service agency or your dealer.

Not intended for use as a primary heat source.

This heater is tested and approved as a decorative heater. It should not be factored as a primary heat source in residential heating calculations.

Do not use outdoors.

This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate heater where it may fall into a bathtub or other water container.

Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or the like. Arrange cord away from traffic area and where it will not be tripped over.

To disconnect heater, turn controls to “OFF”, then remove plug from outlet.

Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.

To prevent a possible fire, do not block air intakes or exhaust in any manner.

A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored.

Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.

Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire. However, if you have to use an extension cord, the cord shall be No. 16 AWG minimum size and rated not less than 1875 watts.

Always use properly grounded fused and polarized outlets.

Always use ground fault protection where required by electrical code.

Always disconnect power before performing any cleaning, maintenance or relocation of the heater.

To prevent a possible fire, do not burn wood or other materials in this heater.

To prevent electric shock or fire, always use a certified electrician should new circuits or outlets be required.

When transporting or storing the heater, keep in a dry place free from excessive vibration and store as to avoid damage.

SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

4

Quadra-Fire • QV26E • 4038-827 Rev E • 02/05

Image 4
Contents Card Congratulations Listing Label Information/LocationTable of Contents Listing and Code Approvals CertificationImportant Instructions Fire RiskGetting Started Tools and Supplies NeededFraming and Clearances Selecting Heater LocationClearances Electrocution RiskModel # Heater LocationsFrame the Heater Framing the HeaterInstallation As a FireplaceShock Risk Shock Risk Fire RiskAs an Insert Glass. Do not install any heater with damaged,Complete or substitute parts Wiring Orange 3 PIN Install the Front Face AccessoriesInstall other Optional Accessories Finishing Checklist FinishingFinishing Material MantelOperating Instructions Main Power SwitchThermostat Troubleshooting Guide TroubleshootingIssues Possible Causes Solutions Maintenance and Service Access the FireboxClean the Firebox Compartment Clean the Back GlassMaintenance Task List When cleaning glass doorHeater Dimensions Reference MaterialsPBT = Polished Brass Trim Optional ComponentsSST = Stainless Steel Trim Fronts Model Description Width HeightService Parts QV26EHearth Assembly Description of PartQty 23/26 Log AssyLimited Warranty How to Obtain ServiceContact Information Hearth & Home Technologies Inc North Highway Coleville, WA

QV26E specifications

Hearth and Home Technologies has long been a leader in the fireplace and heating industry, and their QV26E model stands as a testament to their commitment to innovation and quality. The QV26E is a versatile, zero-clearance gas fireplace that seamlessly blends aesthetics with functionality, catering to both contemporary and traditional home designs.

One of the primary features of the QV26E is its large viewing area. The fireplace boasts a beautifully designed front that allows for an unobstructed view of the flames, creating a warm and inviting ambiance in any room. The large glass door not only enhances the visual appeal but also ensures maximum efficiency by providing better heat retention.

The QV26E is equipped with advanced technology that promotes efficiency and ease of use. Its electronic ignition system allows for reliable startups with the push of a button, eliminating the hassle of traditional match lighting. The model features adjustable flame height, enabling users to customize the intensity of the fire according to their preferences. This adaptability is complemented by a fan-forced heater, which circulates warm air throughout the space, enhancing heat distribution.

Energy efficiency is a hallmark of the QV26E. With an impressive annual fuel utilization efficiency (AFUE) rating, this gas fireplace conserves energy while delivering powerful heating performance. It can be configured for either natural gas or propane, providing flexibility based on the homeowner's needs.

The QV26E also includes easy-to-adjust controls, allowing users to manage the heat output and ambiance without any fuss. Additionally, it comes with a remote control option, enabling homeowners to ignite or extinguish the fire from the comfort of their seats.

Aesthetically, the QV26E offers a variety of styling options. Users can select from different media and log sets to create a personalized look that complements their interior decor. The fireplace is available in multiple finishes, ensuring that it fits harmoniously into any space.

Overall, Hearth and Home Technologies' QV26E model combines safety, efficiency, and beauty, making it a prime choice for those looking to enhance their living environment with a cozy and stylish heating solution. Whether you're looking to create a focal point in your home or simply seeking effective heating, the QV26E delivers in every aspect.