S P E A K E R S E L E C T I O N / V O L U M E C O N T R O L S Y S T E M
3.Make the connections to the SVL-4AB. The amplifier/speaker connectors on the SVL-4AB are removable. If you wish, you may remove the SVL-4AB's connectors to facilitate installation [see (Figure 3)]. Strip 3/8" of insulation from the end of each wire. Tightly twist the end of each wire until there are no frayed ends. Insert each wire into the appropriate hole on the connector terminals. Be certain that proper “phasing” is observed . To achieve proper phasing, connect the positive terminals on the SVL-4AB to the positive terminals on the amplifiers and speakers and the negative terminals on the SVL-4AB to the negative terminals on the amplifiers and speakers. If you are using only one amplifier it should be connected to the “Amplifier A” connector and the pushbutton switches marked “A/B” should be left out or in the “A” position. If you will be using two amplifiers, connect the second amplifier to the “Amplifier B” connector on the SVL-4AB. Re-install the connectors if they were removed. See (Figure 4).
4.Locate the pre-printed Room Labels. Affix the appropriate label to the recessed area over each ON/OFF selector button.
Figure 3
Removing the
Connectors
Figure 4
Installing the Connectors
