Constant Protection Switches

S P E A K E R S E L E C T I O N / V O L U M E C O N T R O L S Y S T E M

9.You can turn off the speakers by turning the correspond- ing volume controls on the SVL-4AB fully counter-clockwise, or by pressing the appropriate ON/OFF button. Refer to the Protection Chart located on page 13 for the correct setting of the PROTECTION button.

SPECIFICATIONS

Audio Power

Handling

100watts/channel continuous music power

10.At any time, you may choose to switch any of the active speaker pairs to one or the other of the amplifiers by pressing the corresponding amplifier A/B button.

The SVL-4AB is equipped with rear panel overrides of the protection circuits that enables you to maintain constant impedance protection regardless of the position of the front panel switch. This will safeguard either or both of your ampli- fiers from being overdriven due to accidental or improper use by anyone unfamiliar with the equipment.

To engage one or both of these overrides, move the rear panel "CONSTANT PROTECTION" switches to the "ON" posi- tion. Constant impedance protection will be maintained until the switches are turned to "OFF".

Frequency Response

+/- 1.2 dB from 20 Hz to 20 kHz

Mounting

Table-Top component

Wiring Requirements

Individual runs of

2-conductor speaker wire. Connectors accommodate wire sizes 14-22 gauge (16 gauge recommended)

Overall Dimensions

17" (432mm) wide x 2" (51mm) high x

9 1/4" (235mm) deep

Weight

7 1/2 lbs. (3.4 kg).