Off | Niles Audio SVL-4AB guide

S P E A K E R S E L E C T I O N / V O L U M E C O N T R O L S Y S T E M

When playing the following speakers:	The Protection button should be:
1 or 2 pair of 8-ohm speakers	OFF
3 or 4 pairs of 8-ohm speakers	ON
1 pair of 4-ohm speakers	OFF
2, 3, or 4 pairs of 4-ohm speakers	ON
Any combination of 4 and 8 ohm speakers	ON

Set the PROTECTION button to the correct position using the chart shown above.

"TECH TIP"

The volume control of your amplifier or receiver acts as the master volume for all of your speaker pairs. Set this control to a comfortable (not maximum)) listening level. Be careful not to overdrive or “clip” your amplifier. If you hear distortion from your speakers reduce the volume of your amplifier to avoid damaging your speakers.

3.Set the SVL-4AB volume controls which correspond to the speaker pairs you wish to play to maximum (fully clockwise).

4.Locate the appropriate ON/OFF buttons on the SVL-4AB. Set them to the ON position.

5.Adjacent to the ON/OFF buttons are the amplifier A/B but- tons. Choose an amplifier for each active speaker pair by pressing the A/B button in for “B” and out for “A”.

6.Turn on the amplifiers or receivers and select a source, such as the tuner or CD player.

7.Slowly turn up each of the amplifiers or receivers volume and set it to a comfortable (not maximum) listening level. Be careful not to overdrive or "clip" your amplifier. If the sound becomes muddy or distorted, you have reached the limit of your amplifier's volume capability and should quickly reduce the volume to avoid damaging your speakers.

8.Using the appropriate volume controls on the front of the SVL-4AB, adjust the volume of the speakers to the desired lis- tening level. The volume control of your receiver or amplifier acts as the master volume for all of your speaker pairs.