Connect Local Source

S T E R E O A M P L I F I E R / A U T O M A T E D S W I T C H E R

3.Use a small flathead screwdriver or your thumbnail to raise the locking tabs, exposing the holes on the removable con- nector plug.

4.Insert each wire into the appropriate hole on the remov- able connector plug, and snap the locking tab down.

NOTE 1: If switching two speaker pairs, repeat steps 1-4 above for SPEAKER B OUT. When switching two pairs, 8 ohm speakers must be used.

A common application for the TVA50 is to be able to switch the speakers used in a whole-house audio system to a TV in a local room. In order to be able to adjust the volume when switched to a local TV, it is necessary to use the variable line level output of the TV when connecting to the TVA50. Doing so will allow the user to adjust the volume using the TV’s remote control, as if the TV speakers were being used.

1.Connect the variable line level output of the TV to the RCA type Line IN jacks on the TVA50.