pour or spill water intocontrol or
motor area, If co_rols get wet, let them dry completely and have unit
checked byauthodzed service per- sonnel before plugging It In.
:_r!_with clean water up to FULL indi-
cator label, located inside the housing on the rear panel(Figure 4).
NOTE: Do not overfill humidifier. Water will overflow from the_overfill hole if
capacity is exceeded.
IMPORTANT
Be sure water does not go above FULb mark or water will overflow from the hole located in the _vater level indica. for label.
Step2
Carefullypour water into humidifier.(Pour water at left of the controls as shown in
Figure4.) | OVERFILL |
HOLE | |
| Figure 4 |
Operating Humidifier | Controls |
Humidity Control: | Fill Light: |
IIIII1[
Adjustthe amount of humiditydepending on user'sneeds. The humidifierwill turn
on and off as requiredto maintain level of humidity you select. (See Figure 5.) MEDIUM setting is recommended but there are times when low or high amount of humidity may be preferred. For con-
stant operationof humidifier,CONSTANT ON allows for the maximum amount of
humidity to be evaporated into the air continuously.
When unit has a small amount of water left in it, a orange fill lightwill come on and unitwill shut off. (See Figure 5.)
IMPORTANT
Water damage may result ff condensa- tion starts to form on windows or
walls. Humidify Control setting should
be lowered until condensation no longer forms.
Air Flow Control:
The higher the air flow speed, the more |
|
water is evaporated and released intothe |
|
air. LOW _peecLis the quietest and is pro- |
|
vided for conditionsthat may not require |
|
as high an evaporation rate. (See Figure |
|
5.) | Figure 5 |