Sears 758.144120, 758.144240 Assembly Instruction, Location Instructions, Electrical Hookup

Humidifier Operations (continued)

CAUTION: Keep your humidifier clean. While humidifiers do not cause colds, some studies sug- gest that dirty humidifiers can cause cold like symptoms in some people. To avoid this, we rec- ommend you clean your humidifier weekly with Humidifier Cleaner 32-7283 and use Bacteriostat 32-14900. These are available at your local Sears store.

DRY ROOM AIR	HUMIDIFIEOAIR	DRYROOMAIR
N	\to	t

WATER

Assembly Instruction

(14 Gallon-Model 758.144240)

Included with this humidifier are two decorative handles

which must be _.t-taelibd to the top of the side panels.

Figure 2

Locate handle and using a screwdriver attach the handle by inserting the screws through the pre-drilled holes in the cabinet housing. This is easiest with motor support removed (see unpacking instructiod_-printed o'ntop of carton).

Location Instructions

I WARNING:ifanytier partsFor youraredamagedownsafety,or missingdonot.use humidi- I

1.Place humidifier in area of house where most humidity is needed, or one which would likely result in moist air being circulated throughout the house such as near a cold air return. Moist air (humidity) produced will dis- perse into the whole house, but area closest to unit will have the highest humidity.

2.Humidifier should sit at least two inches away from wall

for proper operation. Air needs to enter through rear and top louvers in order for humidifier to operate at peak efficiency.

NOTE: Due to release of cool, moist air from humidifier, it is best to direct air away from home'sthermostat and hot air registers. It is best to keep humidifier in front of an

inside wall. Hot air registers and cold air from outside walls can affect the efficiencies of the controls. Unit

should not be placed where warm air from a hot air regis- ter blows directly on unit.

Electrical Hookup

Locate nearest 120V A.C. wall socket in the location

desired, preferably on inside wall. (See Fig. 3)

WARNING: To avoid fire or shock hazard, humidi- I

tier, should be plugged into a 120V, A.C. outlet. Do I not use extension cords.

Figure 3

Lid Retention

1.Locate lid retention clips in styrofoam packing material on top of motor support section. (See Fig. 4) Dispose of packing material.

2.Position lid over housing with hinges facing rear of unit. (See Fig. 5)

3.Position lid retention clip over clip mounting area.

\

Figure 4

4