Sears 153.336362 30 GALLON Temperature Regulation, Temperature Time to Produce 2nd & 3rd

Page 19

Temperature Regulation

Due to the nature of the typical gas water heater, the water temperature in certain situations may vary up to 30F° (16.7 C°) higher or lower at the point of use such as, bathtubs, showers, sink, etc.

Any water heater’s intended purpose is to heat water. Hot water is needed for cleansing, cleaning, and sanitizing (bodies, dishes, clothing). Untempered hot water can present a scald hazard. Depending on the time element, and the people involved (adults, children, elderly, infirm, etc.) scalding may occur at different temperatures.

HOTTER WATER CAN SCALD: Water heaters are intended to produce hot water. Water heated to a temperature which will satisfy space heating, clothes washing, dish washing, and other sanitizing needs can scald and permanently injure you upon contact. Some people are more likely to be permanently injured by hot water than others. These include the elderly, children, the infirm, or physically/mentally handicapped. If anyone using hot water in your home fits into one of these groups or if there is a local code or state law requiring a certain temperature water at the hot water tap, then you must take special precautions. In addition to using the lowest possible temperature setting that satisfies your hot water needs, a means such as a mixing valve, shall be used at the hot water taps used by these people or at the water heater. Mixing valves are available at plumbing supply or hardware stores. Follow manufacturer’s instructions for installation of the valves. Before changing the factory setting on the thermostat, read the Temperature Regulation section in this manual, see Figures 21 and 22.

THE WATER HEATER SHOULD BE LOCATED IN AN AREA WHERE THE GENERAL PUBLIC DOES NOT HAVE ACCESS. IFA SUITABLEAREA IS NOTAVAILABLE, ACOVER SHOULD BE INSTALLED OVER THE THERMOSTAT TO PREVENT TAMPERING. Suitable covers are available through the Sears Service Center.

Never allow small children to use a hot water tap, or to draw their own bath water. Never leave a child or handicapped person unattended in a bathtub or shower.

NOTE: A water temperature range of 120°F-140°F (49°C-60°C) is recommended by most dishwasher manufacturers.

The thermostat of this water heater has been factory set at its lowest position (PILOT LIGHTING). It is adjustable and must be reset to the desired temperature setting to reduce the risk of scald injury. The mark () indicative of approximately 120°F (49°C) is preferred starting point. Some states have a requirement for a lower setting.

Turn the water temperature dial clockwise ( ) to decrease

the temperature, or counterclockwise ( ) to increase the temperature.

Should overheating occur or the gas supply fail to shut off, turn off the manual gas control valve to the appliance.

FIGURE21.

Temperature

Time to Produce 2nd & 3rd

Settings

Degree Burns on Adult Skin

VERYHOT=approx.160°F(71°C)

About 1/2 second

C = approx. 150°F (66°C)

About 1-1/2 seconds

B = approx. 140°F (60°C)

Less than 5 seconds

A = approx. 130°F (54°C)

About 30 seconds

= approx. 120°F (49°C)

More than 5 minutes

LOW = approx. 80°F (27°C)

- - - - - - - - - - - - - - - -

 

 

FIGURE22.

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A Power Miser GAS Water HeaterImportant Definitions Safe INSTALLATION, USE and ServiceSafety Precautions Table of Contents To Install or Operate the Water Heater Product SpecificationsCustomer Responsibilities Basic Tools Additional Tools Needed When Sweat SolderingMaterials and Basic Tools Needed Materials NeededThermostat Typical InstallationPilot & Main Burner Removing the Old Water Heater Installation InstructionsFacts to Consider About the Location Insulation Blankets See on page 9 and below ALL AIR from Inside BuildingsHotter Water can Scald Water PipingValve and Pipe Insulation Temperature-Pressure Relief Valve Venting Filling the Water HeaterGas Piping Sediment Traps GAS Piping with Flexible ConnectorOperating Instructions For Your Safety Read Before LightingTemperature Time to Produce 2nd & 3rd Temperature RegulationVent System Inspection Service and AdjustmentTank Sediment Cleaning Burner CleaningDraining Temperature-Pressure Relief Valve OperationHousekeeping Anode Rod InspectionService Drain Valve Washer ReplacementStart Up Conditions Troubleshooting GuideCondensation Operational ConditionsLeakage Checkpoints Troubleshooting Guide Page Page Parts Order List Burnerassembly153.336466 Gallon 153.336566 153.336962 Burner AssemblyYear Exclusive Kenmore Labor Warranty Year Limited Warranty on Water HeaterWarranty Service

153.336466 40 GALLON, 153.336162, 153.336262 40 GALLON SHORT, 153.336762 30 GALLON PROPANE (L.P.), 153.336362 30 GALLON specifications

Sears offers a range of propane storage tanks designed to meet various domestic and commercial heating needs. Among the popular models are the 40-gallon propane tank (L.P.) with the model numbers 153.336862 and 153.336466, as well as the 50-gallon tank identified by 153.336566, and the 30-gallon propane tank represented by 153.336762. Each of these tanks incorporates modern technologies and features tailored for efficiency, safety, and convenience.

The 40-gallon propane tank is an excellent choice for homeowners looking to efficiently store fuel for heating applications, cooking, or outdoor entertainment. Its compact design allows for easy installation in smaller spaces while ensuring sufficient fuel capacity for moderate consumption needs. The tank is constructed from high-quality steel, providing durability and resistance against environmental factors, ensuring long-lasting service.

Sears also provides the 50-gallon propane tank for users with higher fuel demand. This model is essential for households with larger heating requirements or for businesses utilizing propane for cooking or heating. The larger capacity reduces the frequency of refills and enhances convenience for users.

On the other hand, the 30-gallon propane tank serves as a reliable option for customers with minimal fuel needs. Whether for heating specific areas or powering smaller outdoor appliances, this model offers ample capacity while remaining manageable in size.

Safety features are paramount in all Sears propane tanks. Each tank is equipped with safety valves that prevent over-pressurization, along with a robust design that minimizes the risk of leaks. These tanks also meet stringent safety standards, ensuring users confidence in their performance.

Additionally, all models feature external brackets for easy installation and securing to a solid foundation, reducing the risk of accidents during use or adverse weather conditions. The tanks are compatible with various propane appliances, ensuring versatility across applications.

In conclusion, Sears provides a selection of propane tanks that combine practicality with advanced safety features. Whether users opt for the 30-gallon, 40-gallon, or 50-gallon models, they can trust in the quality and reliability of Sears propane tanks to efficiently meet their fuel storage needs while maintaining safety as a top priority.
Top Page Image Contents