Thermostat Reset Upgrade Kit Installation Instructions
Installation Instructions
1.Pull Pinnacle away from wall. DISCONNECT POWER FROM THE UNIT. Remove lower back panel.
2.Remove the 4 screws holding contactor box cover (bottom rear of unit). The box
will now pivot on hinges. Also remove the 4 screws holding the original safety circuit box on the back of the lower frame.
Contactor Box
Original Safety Box
3.Remove leads LD1 and LD2 from transformer 1, located in contactor box. These are the piggybacked connections. Remove the labeled terminals from the piggybacks and replace in their original positions.
Place
Use same location from placement.
Remove piggybacked wires and leads from transformer.
Publication Number: 629088480INS | - 2 - | © 2005, IMI Cornelius Inc. |