Thermostat Reset Upgrade Kit Installation Instructions
4.Remove thermostat wires from their connections. Feed the wires out of the contactor box. Discard the black jumper wire.
Disconnect white
contactor wire from
thermostat wire.
Disconnect black
jumper from thermostat
wire and discard.
5.Feed the white wires that originate from the safety circuit box out of the contactor box.
Remove the two white wires and black thermostat wires from contactor box.
6.Pull out safety circuit box and remove the ground screw. Disconnect the main power and contactor harness leads for the contactor.
7.Feed the white wires out through the hole and remove the box.
NOTE: Note the mounting hole locations on the original box. If the mounting holes are on the side of the box, proceed to step 14.
If the mounting locations are on the top and bottom, remove all wires and bushing and proceed to the next step to drill new mounting holes.
Box with mounting holes on top and bottom. Drill new.
Box with mounting holes on sides. Use existing.
© 2005, IMI Cornelius Inc. | - 3 - | Publication Number: 629088480INS |