Cornelius 629088480 installation instructions Check CorrectIncorrect

Page 7

Thermostat Reset Upgrade Kit Installation Instructions

20.Place the stainless steel lock-washer over the brass screw and thread it in (a “screw starter” screwdriver makes this much easier).

NOTE:

Make sure both screws are in place and secure.

Do not use power tools to drive screws.

Use caution not to overtighten the screw.

21.Insure screw is flush and sealed against lock washer, as shown.

22.Repeat procedure for second screw.

23.Repeat steps 18-20 for all barrels.

If the existing screws do not come out or they break during this change, call IMI Cornelius Service at 800- 238-3600.

24.After screw replacements, insure thermostat is flush against brass retaining nut, by grasping the body of the thermostat with your finger and gently trying to wiggle it. No movement should be detected. If movement is detected, tighten screws and recheck.

Check

CorrectIncorrect

WARNING: If thermostat is loose, it will not correctly detect an over temperature condition. This could allow product to overheat without being detected.

© 2005, IMI Cornelius Inc.

- 7 -

Publication Number: 629088480INS

Image 7
Contents Qty DescriptionInstallation Instructions Publication Number 629088480INS Place template, as shown, between frame and hoses Feed the remaining 4 wires 2 red, 2 orange through hole Disconnect wires here Remove wire tie, if present Check CorrectIncorrect Route extra wire back into unit Protection harnesses Make Sure this is the Board Terminal Labeled P4