Niles Audio SI-1230 Speaker Wire Connections, Label all wires, Banana plug to the black terminal

Speaker Wire Connections

CAUTION! All speaker wire connections must be made with the amplifier Off.

INSTALLATION

Bare Wire

Unscrew the red or black plastic knob, insert the bare wire end into the opening, and then tighten the knob until the wire is securely clamped.

Banana Plugs

There are many types of banana plugs, some crimp, some solder. The Niles gold banana plug has a quick-con- nect binding post for the bare wire on the body of the plug. A banana plug is simply inserted into the jack at the end of the ampli- fier’s binding post. Dual banana plugs will fit the SI-1230 binding posts.

STEP
1. Label all wires.	If you label the wires for their destination,
	rather than which terminal of the SI-1230
	they are connected to, it will be easier to
	reconfigure your system in the future.
2. Connect one stripped wire end or	A. Split the speaker wire insulation so that
	at least two inches of each conductor are
banana plug to the black terminal	separated.
and one to the red terminal.	B. Strip one half inch of insulation from the
	end of each conductor of the speaker wire
CAUTION- Avoid even a single strand	C. Attach banana plugs or twist the strands of
	wire together and insert them into the appro-
of wire touching the chassis or another	priate binding post.
connector.
DESCRIPTION

22