INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation. The parts supplied are in the washer drum.
Tools needed for connecting the water inlet hoses
•Pliers (that open to 19/16"[39.5 mm])
•Flashlight (optional)
Tools needed for installation
•Open end wrenches 17 mm and 13 mm
•Level
•Wood block
•Ruler or measuring tape
Parts supplied
A
C
0
A. Drain | hose | form | D. Transportbolt hole |
B. Inlet | hose | (2) | plug (4) |
C. Inlet | hose | washer (4) | E. Beaded strap |
Alternate Parts
Parts listed are available from your local Sears store or Sears Service Center. For further information, please call
Pedestal
You have the option of purchasing a pedestal for this washer. You may select a 10" (25.4 cm) pedestal. Remember that the pedestal will add to the total height of the unit.
Optional pedestal
To order, call your local Sears store. For further information, please call
Pedestal | Approximate height | Color | Model |
Height | with washer |
| Number |
10" (25.4 cm) | 46" (116.8 cm) | White | 46822 |
iiii.......
Stack Kit
Are you planning to stack your Kenmore washer and dryer? To do so, find the stack kit (Part Number 8572546) in the drum of the matching Kenmore dryer. Follow instructions included with the kit. See "Location Requirements."
Selecting the proper location for your washer improves
Laundry tub or standpipe taller than 96" (2.4 m)
Overhead sewer
Floor drain
Drain hose too short
Water faucets beyond reach of fill hoses
Sump pump system (if not already available)
Standard 20 gal. (76 L), 30" (76.2 cm) tall drain tub or utility sink and sump pump (available from local plumbing suppliers)
Siphon break, Part Number 285834; additional drain hose, Part
Number 8318155; and connector kit, Part Number 285863
4 ft (1.2 m) drain hose extension kit, Part Number 285863
2 longer water fill hoses:
6 ft (1.8 m) Part Number 76314
10 ft (3.0 m) Part Number 350008
basement, laundry room, closet, or recessed area. See "Drain System."
Companion appliance location requirements should also be considered. Proper installation is your responsibility.
You will need
•A water heater set to deliver 120°F (49°C) water to the washer.
•A grounded electrical outlet located within 6 ft (1.8 m) of where the power cord is attached to the back of the washer. See "Electrical Requirements."
•Hot and cold water faucets located within 4 ft (1.2 m) of the hot and cold water fill valves, and water pressure of
•A level floor with a maximum slope of 1" (2.5 cm) under entire washer. Installing the washer on soft floor surfaces, such as carpets or surfaces with foam backing, is not recommended.
A sturdy and solid floor to support the washer with a total weight (water and load) of 400 Ibs (180 kg).
Do not operate your washer in temperatures below 32°F (0°C). Some water can remain in the washer and can cause damage in low temperatures.
